Abstract:It is demonstrated that the power consumption can be reduced to ≈53.7 fJ in a phase change memory cell with ≈3 nm‐wide graphene nanoribbon (GNR) as edge‐contact, whose cross‐sectional area reaches only ≈1 nm2. The asymmetric structure in the device enables the finding that the polarity of bias pulse determines its cycle endurance. Nonvolatile phase‐change random access memory (PCRAM) is regarded as one of the promising candidates for emerging mass storage in the era of Big Data. However, relatively high programming energy hurdles the further reduction of power consumption in PCRAM. Utilizing narrow edge‐contact of graphene can effectively reduce the active volume of phase change material in each cell, and therefore realize low‐power operation. Here, it demonstrates that the power consumption can be reduced to ≈53.7 fJ in a cell with ≈3 nm‐wide graphene nanoribbon (GNR) as edge‐contact, whose cross‐sectional area is only ≈1 nm2. It is found that the polarity of the bias pulse determines its cycle endurance in the asymmetric structure. If a positive bias is applied to the graphene electrode, the endurance can be extended at least one order longer than the case with a reversal of polarity. In addition, the introduction of the hexagonal boron nitride (h‐BN) multilayer leads to a low resistance drift and a high programming speed in a memory cell. The work represents a great technological advance for the low‐power PCRAM and can benefit in‐memory computing in the future.

Lower Power, Better Uniformity, and Stability CBRAM Enabled by Graphene Nanohole Interface Engineering

A Physics-based Compact Model for Set Process of Resistive Random Access Memory (RRAM) with Graphene Electrode

Modeling and Simulation of Resistive Random Access Memory with Graphene Electrode

Kinetic Monte Carlo Simulations on Electroforming in Nanomanipulated Conductive Bridge Random Access Memory Devices

Atomically Thin CBRAM Enabled by 2-D Materials: Scaling Behaviors and Performance Limits

Graphene: Confining Cation Injection to Enhance CBRAM Performance by Nanopore Graphene Layer (small 35/2017)

The Origin of CBRAM With High Linearity, On/Off Ratio, and State Number for Neuromorphic Computing

Self-compliance and High-Performance GeTe-based CBRAM with Cu Electrode

Spatial Correlation of Conductive Filaments for Multiple Switching Cycles in CBRAM

Minimizing the Programming Power of Phase Change Memory by Using Graphene Nanoribbon Edge‐Contact

A Physics-Based Compact Model for CBRAM Retention Behaviors Based on Atom Transport Dynamics and Percolation Theory

Improvement of Device Reliability by Introducing a BEOL-Compatible TiN Barrier Layer in CBRAM

Scaling the CBRAM Switching Layer Diameter to 30 nm Improves Cycling Endurance

Atomic Monte-Carlo Simulation for CBRAM with Various Filament Geometries

Cluster-Type Filaments Induced by Doping in Low-Operation-Current Conductive Bridge Random Access Memory

Interface Engineering Via MoS2 Insertion Layer for Improving Resistive Switching of Conductive‐Bridging Random Access Memory

Modeling and Simulation of RRAM with Carbon Nanotube Electrode

Two-Dimensional (2D) Materials-Inserted Conductive Bridge Random Access Memory: Controllable Injection of Cations in Vertical Stacking Alignment of MoSe 2 Layers Prepared by Plasma-Assisted Chemical Vapor Reaction

Highly Compact 1T-1R Architecture (4f(2) Footprint) Involving Fully Cmos Compatible Vertical Gaa Nano-Pillar Transistors and Oxide-Based Rram Cells Exhibiting Excellent Nvm Properties and Ultra-Low Power Operation

A Compact Model for Electro-Thermal Simulation of Resistive Random Access Memory With Graphene Electrode