Abstract:At present, there is a great interest in the development of new airfoils for wind turbines and high-lift wings of unmanned aerial vehicles (UAV). The requirements for such airfoils differ from conventional aircraft airfoils, because of structural reasons and extreme operating conditions. So, wind turbine airfoils operate frequently under fully separated flow when stall is used for power regulation at high wind speeds. At the same time design of airfoils for wings UAV poses the problem of availability of high-lift at low Reynolds number. Modern airfoils are to a large extent developed from numerical methods. However, the complex flow conditions such as separation at high angles of attack, laminar separation bubbles and the transition from laminar to turbulent flow are difficult to predict accurately. Hence, testing of airfoils at a two-dimensional condition is an important phase in airfoil design. The development and validation of a 2D testing facility for investigation of single and multi-element airfoils in the wind tunnel Т-102 with open test section are considered in this article. T-102 is a continuous-operation, closed-layout wind tunnel with two reverse channels. The test section has an elliptical cross-section of 4 ×2,33 m and a length of 4 m. Two big flat panels of the L × H=3 ×3,9 m size installed upright on balance frame aligned with the free stream are used for simulating two-dimensional flow in the tunnel test section. The airfoil section in the layout of a rectangular wing is mounted horizontally between flat panels with minimum gaps to ensure 2D flow conditions. The aerodynamic forces and pitch moment acting on the model were measured by wind tunnel balance. To determine boundary corrections for a new test section of wind tunnel, the experimental investigation of three geometrically similar models has been executed. The use of boundary corrections has provided good correlation of the test data of airfoil NACA 6712 with the results obtained from the wind tunnel except for lift and drag coefficient values at high angles of attack.

Wind Tunnel Experiments of Novel Wing Configurations for Design and Customisation in an Industry 4.0 Environment.

Aerodynamic Analysis and Design Numerical Simulation of the Vortex Flow over a Common Research Model with Flying-Wing Configuration

Low Observable Uncrewed Aerial Vehicle Wind Tunnel Model Design, Manufacturing, and Aerodynamic Characterization

SIMULATION OF 2D FLOW AROUND OF AIRFOILS AT LOW-SPEED WIND TUNNEL WITH OPEN JET TEST-SECTION

Versatile wind tunnel and CFD-based optimal design

Experimental design for a novel co-flow jet airfoil

Learning Active Flow Control Strategies of a Swept Wing by Intelligent Wind Tunnel

Research Progress in Numerical Simulation of Aircraft Wing Flow Field

Reliable method of aerodynamic analysis using computational fluid dynamics and scaled models in the development process of a Very Light Airplane

Interactive Effects of Wind Tunnel Sidewalls on Flow Structures Around 2D Airfoil Model

Present Research Status and Prospective Application of Wind-Tunnel Free-Flight Test Technique

How to Design a 2D Active Grid for Dynamic Inflow Modulation

The reproduction of 2-D non-synoptic wind field in an actively controlled wind tunnel

Experimental research on the high angle of attack aerodynamic characteristics of an 80°/65° double-delta wing

An Inverse Design Method for Wing Shape Optimization Guided by Spanwise Lift Distribution

Low-Speed Open Return Wind Tunnel Aerodynamic Design and Numerical Calculation

Numerical and Experimental Investigation of A Three-Axis Free Rotation Wind Tunnel Model

Wind Tunnel Experiment and Numerical Simulation of Secondary Flow Systems on a Supersonic Wing

Wake Dynamics of Finite Aspect Ratio Wings. Part I: an Experimental Study

A Parametric Design Method for Hybrid Airfoils for Icing Wind Tunnel Test

Generalized, Three-Dimensional Wind Tunnel Wall Correction Using Nonlinear Least-Squares Optimization