Abstract:One static and four dynamic collapse experiments have been conducted on beam-column assemblies under a middle-column removal scenario to investigate the dynamic collapse responses. All the assemblies had identical configurations, materials, and boundary conditions. Numerical analyses were conducted for an in-depth comprehension of different behaviors of the assemblies under static and dynamic collapse scenarios. To ease the assessment of the dynamic collapse responses of the beam-column assemblies, a new assessment procedure was proposed based on the energy-method and was proved to be efficient and accurate by comparing with the experimental and numerical results. Research indicated that the dynamic collapse behaviors of the assemblies were influenced by two key factors, i.e., the dynamic stress distribution characteristics and the material strain rate effect. Under the dynamic collapse scenario, the structural resistance of the assemblies was impaired during the stage of compressive arch action (CAA) due to the dynamic stress distribution characteristics. Whereas the material strain rate effect could enhance the resistance in the stage of the catenary action (CA). Moreover, both factors contributed to increasing the largest deformation of the assemblies. The dynamic amplification factor (DAF) was also evaluated based on the proposed assessment procedure and the traditional one. At the critical deformations during the CAA and CA stages, the DAFs obtained through the proposed procedure were found to be greater than those determined by the traditional procedure in which the dynamic stress distribution characteristics and the material strain rate effect were both neglected. Further, the DAFs suitable for practical engineering design were also discussed.

Dynamic In‐Plane Compression of Asymmetric Metal Corrugated Sandwich Columns

Dynamic Collapse of Metal Self-Similar Hierarchical Corrugated Sandwich Plates Subject to Shear and Compression Coupled Loading

Dynamic Collapse of Metal Self-Similar Hierarchical Corrugated Sandwich Plates

Compressive Strengths and Dynamic Response of Corrugated Metal Sandwich Plates with Unfilled and Foam-Filled Sinusoidal Plate Cores

Dynamic compressive response of metal orthogonal corrugated sandwich structure

Dynamic Collapse of Circular Metal Foam Core Sandwich Tubes in Splitting and Curling Mode

Quasi-static Compressive Behavior of U-type Corrugated Cores Sandwich Panels

Axial Low-Velocity Impact of Sandwich Columns with Aluminum Face-Sheets and Hexagonal Honeycomb Core

Numerical Study on Buckling Behaviors of Thin-Walled Longitudinal Corrugated Cylindrical Shells under Axial Compression Loads

Axial Compressive Collapse of Ultralight Corrugated Sandwich Cylindrical Shells

Splitting and Curling Collapse of Square Sandwich Metal Tube with Aluminum Foam Core under Axial Low-Velocity Impact

Splitting and Curling Collapse of Metal Foam Core Square Sandwich Metal Tubes: Experimental and Theoretical Investigations

Dynamic Crushing of All-Metallic Corrugated Panels Filled With Close-Celled Aluminum Foams

Compressive Behaviour of Corrugated Board Panels

Numerical study on the axial collapse of thin-walled columns

Experimental and numerical simulation of dynamic response of U-type corrugated sandwich panels under low-velocity impact

The Load-Carrying Capacity of Sandwich Beams in Different Collapse Mechanisms

Experimental and Numerical Investigation on the Crushing Behavior of Sandwich Composite under Edgewise Compression Loading

On axial splitting and curling behaviour of circular sandwich metal tubes with metal foam core

Experimental and numerical investigation of dynamic progressive collapse of reinforced concrete beam-column assemblies under a middle-column removal scenario

Effect of Foam-Filling on Collapse Mode Transition of Thin-Walled Circular Columns under Axial Compression: Analytical, Numerical and Experimental Studies