Abstract:Catalytic decomposition of benzene was studied by using oxides of vanadium and tungsten supported on titanium oxide (TiO2) catalysts for effective reduction of emissions of toxic organic compounds from waste incineration. Experiments were conducted to evaluate the effects of the catalyst's composition, and operating conditions on benzene decomposition, and the relationship between molecular structures of catalysts and their activity was also investigated through replacing the conventional TiO2 catalyst support by nano-sized TiO2. Trace levels (1 and 10 ppm) of gaseous benzene were catalytically decomposed in a fixed-bed catalytic reactor with monolithic oxides of vanadium and tungsten supported on titanium oxide (V2O5-WO3/TiO2) catalysts under conditions simulating the cooling of waste incineration flue gas. On-line monitoring of trace benzene concentrations before and after the catalyst was achieved by means of resonance enhanced multiphoton ionization-time of flight mass spectrometry (REMPI-TOFMS). Catalysts were characterized by nitrogen adsorption, X-ray diffraction, energy dispersive X-ray spectroscopy, temperature-programmed reduction, and Raman spectroscopy. The effects of several parameters, including catalyst operating temperature, space velocity (SV) and initial benzene concentration, on catalytic oxidation of benzene were investigated. Experimental results indicate that reduction of the initial benzene concentration from 10 to 1 ppm either enhances or decreases the catalytic removal efficiency depending on the adsorption capability as well as the oxidation ability of the catalyst tested. The catalytic activity for benzene oxidation not simply relies on the vanadium content of the catalyst; the molecular structure of vanadium oxide, which is known to be influenced by both vanadium oxide loading and the type of support, is very important. Nano-sized TiO2 supported vanadium oxide catalyst (VWNT) with lowest V loading (0.75 wt.%) provides higher catalytic activity than those of the catalysts with higher V contents (1.31 and 2.92 wt.%) but supported by conventional TiO2 (VWT1 and VWT2). The relatively higher catalytic activity of VWNT may be attributed to: (a) the presence of monomeric VOx species, with one terminal V=O bond as indicated by Raman spectra; (b) fewer impurities confounding active catalytic constituents (V, W and Ti); (c) pure anatase phase of TiO2 rather than a mixture phase of anatase and rutile servicing as catalyst support besides its nano-scale particle size; (d) larger specific surface area, smaller average pore diameter, and narrower pore size distribution contribute higher adsorption ability for benzene. No obvious competition effect between NOx removal and benzene oxidation was observed in this study. Reaction rate constants and activation energies for benzene catalytic oxidation tested by the catalysts were calculated. Lower activation energy obtained from VWNT than those of the two catalysts further confirming the higher catalytic activity of VWNT. Published by Elsevier B.V.

Effective Low‐temperature Catalytic Abatement of Benzene over Porous Mn‐Ni Composite Oxides Synthesized Via the Oxalate Route

Enhanced Performance of Binary WO3/N-doped Carbon Composites for the Catalytic Oxidation of Benzyl Alcohol under Mild Conditions

In Situ Fabrication of Highly Active Γ-Mno2/smmno3 Catalyst for Deep Catalytic Oxidation of Gaseous Benzene, Ethylbenzene, Toluene, and O-Xylene.

Low-Temperature Benzene Abatement over Active Manganese Oxides with Abundant Catalytic Sites

Catalytic Removal of Benzene at Mild Temperature over Manganese Oxide Catalysts

Low temperature chlorobenzene catalytic oxidation over MnOx/CNTs with the assistance of ozone

Catalytic Activity of Porous Manganese Oxides for Benzene Oxidation Improved Via Citric Acid Solution Combustion Synthesis

Study on the Decomposition of Trace Benzene over V2O5–WO3/TiO2-based Catalysts in Simulated Flue Gas

Oxygen-dependent Catalytic Activity of Mesoporous MnCO3-based Catalysts for Highly Effective Benzene Oxidation

Oxygen-dependent catalytic activity of mesoporous MnCO 3 -based catalysts for highly effective benzene oxidation

Catalytic oxidation of benzene using mesoporous alpha-Mn2O3

Generalized and High Temperature Synthesis of a Series of Crystalline Mesoporous Metal Oxides Based Nanocomposites with Enhanced Catalytic Activities for Benzene Combustion

Promoted Catalytic Oxidation of Benzene over Mn-Ni Solid Solutions: Effect of Metal Oxygen Bond Parameters

Synthesis of -MnO<sub>2</sub>-like rod catalyst using YMn<sub>2</sub>O<sub>5</sub> A-site sacrificial strategy for efficient benzene oxidation

Promoted catalytic performance of Ag-Mn bimetal catalysts synthesized through reduction route

Catalytic Oxidation of Benzene over Atomic Active Site AgNi/BCN Catalysts at Room Temperature

Ozone-catalytic Oxidation of Gaseous Benzene over MnO2/ZSM-5 at Ambient Temperature: Catalytic Deactivation and Its Suppression

Enhanced catalytic activities of MnOx/Co3O4 nanocomposites prepared via MOFs-templated approach for chlorobenzene oxidation

Regulation of Oxygen Vacancies in MnCO3-based Catalysts by Thermally Inducing for Efficiently Catalytic Benzene Combustion

Facile synthesis -MnO<sub>2</sub> spinel for highly effective catalytic oxidation of benzene

Low-temperature Catalytic Oxidation of Chlorobenzene over MnOX/TiO2–CNTs Nano-Composites Prepared by Wet Synthesis Methods