Abstract:The low-cycle fatigue of strongly-textured Mg alloys is dominated mainly by an alternation of twinning-detwinning process, which poses a great challenge to conventional constitutive models. As a result, a good reproduction of both mechanical response and deformation behavior often fails in previous simulations, in particular for high strain amplitudes. In the present study, the numerical simulations of low-cycle fatigue behavior of an Mg AZ31 plate with a ± 2% axial strain amplitude along the rolling direction were conducted, using a modified crystal-plasticity based on the finite strain elastic-viscoplastic self-consistent model containing twinning and detwinning mechanisms (EVPSC-TDT), and the results were compared with the mechanical response and deformation behavior determined by a real-time in-situ neutron diffraction. The simulations well predict the hysteresis loops and cyclic-hardening responses throughout the whole fatigue life (80 cycles), along with the evolution of the maximum twin volume fraction and residual twins. For the first time, the evolution of lattice strain throughout the whole fatigue life was calculated, and the results are in good accordance with that determined by neutron diffraction. The present study strongly demonstrates that the EVPSC-TDT model is very effective for modeling the low-cycle fatigue behavior of Mg alloys. More details about the evolution of the maximum twin volume fraction with fatigue cycles are found, an increase from 1st to 2nd cycle, followed by a decrease from 2nd to 20th cycle and a secondary increase after 20th cycle. This finding corrects the previous opinion that the maximum twin volume fraction increases at the initial stage and tends to be saturated at the late stage. Combining the results of simulations and neutron diffractions, the corresponding reasons are explained. Afterward, the mechanisms of the cyclic-hardening behavior at tension stage and compression stage are revisited, and some new insights are provided.

Inhomogeneous Deformation Growth of a Metal under Cyclic Loading and Its Influence on Fatigue

The Meso-inhomogeneous Deformation of Pure Copper under Tension–Compression Cyclic Strain Loading

Analysis of Meso-Inhomogeneous Deformation on a Metal Material Surface under Low-Cycle Fatigue

Grain-level Statistical Plasticity Analysis on Strain Cycle Fatigue of a FCC Metal

Modeling the Strain Rate-Dependent Constitutive Behavior in Nanotwinned Polycrystalline Metals

Anisotropy of Yielding/Hardening and Micro-Inhomogeneity of Deforming/Rotating for A Polycrystalline Metal under Cyclic Tension Compression

Constitutive Modeling of Slip, Twinning and Detwinning for Mg Alloy and Inhomogeneous Evolution of Microstructure

Prediction Of Strain Fatigue Life Of Hrb400 Steel Based On Meso-Deformation Inhomogeneity

Application of Differential Entropy in Characterizing the Deformation Inhomogeneity and Life Prediction of Low-Cycle Fatigue of Metals

Mechanical Behaviour and the Evolution of the Dislocation Structure of Copper Polycrystal Deformed under Fatigue–tension and Tension–fatigue Sequential Strain Paths

A Crystal Plasticity Model of Low Cycle Fatigue Damage Considering Dislocation Density, Stress Triaxiality and Lode Parameter

Strain-induced Dissolution of Cu–Mg Co-Clusters and Dynamic Recrystallization Near a Fatigue Crack Tip of an Underaged Al–Cu–Mg Alloy During Cyclic Loading at Ambient Temperature

Low Cycle Fatigue Behavior of Cu‐Cr‐Zr Alloy with Different Cold Deformation

Effect of Loading Modes on Uniaxial Creep-Fatigue Deformation: a Dislocation Based Viscoplastic Constitutive Model

Crystal plasticity modeling of low-cycle fatigue behavior of an Mg-3Al-1Zn alloy based on a model, including twinning and detwinning mechanisms

Investigation of Deformation Inhomogeneity and Low-Cycle Fatigue of a Polycrystalline Material

Strain-gradient dependent fatigue behavior of micron-thick copper single crystal foils

Effect of Fatigue Behavior on Microstructural Features in a Cast Al-12Si-CuNiMg Alloy under High Cycle Fatigue Loading

The Fatigue Limits of Copper Single Crystals Cyclically Deformed at Constant Plastic Strain Amplitudes

Meso-scale low-cycle fatigue damage of polycrystalline nickel-based alloy by crystal plasticity finite element method

A Constitutive Model for Metal Plastic Deformation at Micro/meso Scale with Consideration of Grain Orientation and Its Evolution