Abstract:Assorted morphologies of precipitates in fcc/bcc transformation systems have been reported, which often exhibit irrational characteristic. Various models have been developed to explain the habit plane (or the broad facet), but the overall morphologies of the precipitates are seldom explained quantitatively. In this work, the equilibrium cross-section of rod-shape austenite precipitates in duplex stainless steel is determined by atomistic simulation. The input orientation relationship (OR) between fcc and bcc phase is determined according to the O-line criterion (one of the interfaces contains a single set of dislocations), with the condition that the invariant line lies in close-packed plane pair of (1 (1) over bar(1) over bar)(f)|(10 (1) over bar)(b) and the Burgers vector of O-lines is [011](f|)/2|((1) over bar 11)(b)/2. The obtained OR is close to the K-S OR ((11 (1) over bar)(f)//(01 (1) over bar)(b), [101](f)//(111)(b)), with the deviation of 1.27 degrees from the parallelism in both planes and directions. Interfacial energy of interfaces in various orientations in the zone axis of the invariant line ([0.75 0.10 0.65](f)//[0.52 0.68 0.52](b)) has been calculated. To ensure the reliability of the calculated values, an initial atomic configuration free of interstitial and vacancy is constructed for each interface. The energies of the O-line interface, the interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) are found to have similar values, each at a local minimum. Based on the calculated interfacial energies, the equilibrium cross-section morphology is determined by the Wulff construction. The result shows that the morphology exhibits a near rhombus cross-section, which agrees consistently with experiments. One of the major facets is the O-line interface, normal to ((0.66) over bar 0.12 0.74)(f)//((0.51) over bar (0.24) over bar 0.83)(b), in agreement with the observation. The other facet is normal to Delta g((020)) (((0.25) over bar (0.87) over bar 0.42)(f)//(0.45 (0.73) over bar 0.51)(b)) in the calculated result, while it is normal to Delta g(((1) over bar 11)) (((0.36) over bar (0.77) over bar 0.53)(f)//(0.31 (0.71) over bar 0.63)(b)) in experimental results, with about 10 degrees difference between them. The discrepancy between calculated and observed results is probably because the experiments have not reached the equilibrium state. The dislocation structures in these three interfaces are identified from the atomic simulation results by a newly developed method based on the singular value decomposition of the Nye tensor. It confirms that the O-line interface contains a single set of [011](f)/2 dislocations with spacing of 1.5 nm. The interface normal to either Delta g(((1) over bar 11)) or Delta g((020)) contains two sets of dislocations. The dislocation structure in the facet normal to Delta g((1) over bar 11)) is in good agreement with experimental observation of the non-O-line facet, including the local decomposition of dislocation core to (1 (1) over bar(1) over bar)(f) stacking faults.

First-principles Study on the Equilibrium Shape of Nanometer-Sized Body-Centered Cubic Cu Precipitates in Ferritic Steels

The energetic and structural properties of bcc NiCu, FeCu alloys: A first-principles study

Deformation of Fe and Ag Precipitates in Cu Matrix

Thermodynamic and mechanical properties of copper precipitates in alpha-iron from atomistic simulations

A First-Principles Study of the Structural, Mechanical and Electronic Properties of Precipitates of Al2Cu in Al-Cu Alloys.

First-principles study of effects of alloying elements on Cu/γ-Fe interfacial properties

First-principle Study of Interfacial Properties of Ni–Ni3Si Composite

Density functional theory investigation on the stability, adhesion strength, tensile properties and fracture behavior of γ-Fe/Cu heterogeneous nucleation interface

Atomic-scale study on core-shell Cu precipitation in steels: atom probe tomography and ab initio calculations

POSITRON ANNIHILATION STUDY FOR ELECTRONIC STRUCTURE OF CU PRECIPITATES IN DILUTE FE-CU ALLOYS

Improving thermal stability and Hall-Petch breakdown relationship in nanocrystalline Cu: A molecular dynamics simulation study

First-Principles Calculation on the Influence of Alloying Elements on Interfacial Features of W-Cu System

First-principles calculation of self-interstitial atom-impurity atom interactions in ferritic steel

Phase field study of the copper precipitation in Fe-Cu alloy

An Investigation on the Equilibrium Morphology and Interfacial Structures of Pricipitates in Duplex Stainless Steel by Atomistic Simulation

First-principles Investigation of the Effect of Interfacial Compositions on the Formation Energies of Ω′ and T1 Structures

Single-Layer Fe-Cu Interphase in Ferritic Steels Stabilized by Magnetic Friedel Oscillations

First principle study of cobalt impurity in bcc Fe with Cu precipitates

First-principle investigation on the interfacial structure evolution of the δ'/θ'/δ' composite precipitates in Al-Cu-Li alloys

Atomistic Simulation of Interactions Between an Edge Dislocation and Cu Precipitates with Different Chemical Compositions in Α-Fe

Ab Initio Study of Energetics, Charge Transfer, and Atomic Structures of FCC Fe/NbC Interfaces with and Without N Doping: from Coherent to Semi-coherent Interfaces