Towards Low Emissions and High Thermal Efficiency of Gasoline Compression Ignition Engine under High Loads by Modulating the Fuel Reactivity and Injection Strategy

ChenXu Jiang,ZiLong Li,Yong Qian,XingCai Lu

DOI: https://doi.org/10.1007/s11431-019-1436-y

2020-01-01

Science China Technological Sciences

Abstract:Gasoline compression ignition (GCI) is a practicable way to obtain low emissions and high thermal efficiency of gasoline-like fuels in internal combustion engines. In this paper, the research octane number (RON) and injection strategy were coordinated to optimize the GCI engine performance and emissions under high loads. The direct injection and port injection were used to achieve two injection strategies: direct injection (DI) and port injection plus direct injection (PIDI), and the primary reference fuels (PRF) with the RON of 60, 70, 80 and 90 were used. The results show that using lower RON fuels under high loads, DI mode can achieve higher efficiency, while PIDI mode can achieve lower combustion noise at an expense of slightly lower fuel economy. When the DI mode is converted to PIDI mode with a pre-injection ratio of 30%, using PRF70 under 12 bar and the exhaust gas recirculation (EGR) rate of 40%, the gross indicated thermal efficiency and the maximum pressure rise rate are reduced by 1% and by 2 bar/°CA, respectively, while the particle emissions also decrease significantly, thus achieving low emissions and high efficiency. However, under the same load and EGR rate, DI mode produces less regulated and unregulated emissions than PIDI mode. In addition, the effect of fuel RON was obvious, the lower RON fuels exhibit obvious three-stage heat release in PIDI mode, however, PRF90 with higher RON only exhibits two-stage heat release, and the peak value of the first-stage heat release rate is also lower than those of other fuels.