Abstract:The flow boiling heat transfer characteristics of NH3/H2O mixture in a 2D single horizontal microchannel (0.4 mm width × 6 mm length) were investigated by Computational Fluid Dynamics (CFD) method. The multiphase VOF model and modified phase change Lee method were adopted to address the non-isothermal phase change process of the flowing zeotropic NH3/H2O mixture, while the variations of the binary mixture thermophysical properties were also taken into account. The effects of mass flux (46~552 kg/(m2∙K)), inlet NH3 concentration (0-35% by mole) and heating wall temperature (20.5~70 <math>∘C</math>) on the overall and local flow boiling heat transfer performance have been comparatively evaluated under constant heating wall temperatures. According to the numerical results, the heat dissipation rate of NH3/H2O mixture flow boiling could reach up to 1.41 MW/m2 at a mass flux of 552 kg/(m2∙s), which was 2.05 times of water single-phase flow cooling under a same constant heating wall temperature of 50 <math>∘C</math>. It was also revealed that, for NH3/H2O mixture flow boiling in the microchannel, there was a threshold of inlet NH3 concentration to maintain a certain level of heat dissipation rate at a given mass flow rate and further increasing the inlet NH3 concentration would no longer benefit the heat dissipation process. Furthermore, there were no local dry-outs found throughout the whole microchannel length under all the simulation conditions in this study, which could be attributed to the unique flow boiling behaviors of zeotropic NH3/H2O mixture. Therefore, it should be noticed that NH3/H2O mixture, under certain conditions, could be a good alternative coolant for preventing local dry-outs and maintaining a certain functional temperature of electronic components.

Effect of Miscible Oil on Flow Boiling Heat Transfer Characteristic of Ammonia in a 4 Mm Small Tube

Effect of Oil on Flow Pattern and Heat Transfer Characteristic of R410A Flow Boiling inside Small Diameter Smooth Tubes

Flow boiling heat transfer and dryout characteristics of ammonia in a horizontal smooth mini-tube

EXPERIMENTAL INVESTIGATION AND CORRELATION OF TWO-PHASE HEAT TRANSFER OF R410A/OIL MIXTURE FLOW BOILING IN A 5-MM MICROFIN TUBE

Influence of Lubricant Oil on Heat Transfer Performance of Refrigerant Flow Boiling Inside Small Diameter Tubes. Part I: Experimental Study

Heat Transfer Characteristics Of Ammonia During Flow Boiling In A Horizontal Small Diameter Tube

Measurement and Correlation of Flow-Boiling Heat Transfer of a R-410A/Oil Mixture Inside a 4.18 Mm Straight Smooth Tube

Numerical investigations on flow boiling heat transfer of ammonia water binary solution (NH3/H2O) in a horizontal microchannel

Low temperature simulation of ammonia refrigeration based on dissipative molecular dynamics

Study of Heat Transfer for Co2 Flow Boiling in Horizontal Small Diameter Tubes

Stratification and Heat Transfer Characteristics for R32-partially Miscible Oil Mixture Flow Boiling Inside a Micro-Fin Tube

Ammonia flow boiling in the smooth, annuli and inner-finned tube at different gravity orientation

Experimental Study of Flow Boiling Instabilities in Horizontal Tubes under Gas–liquid Stratification Condition: Effects of Heat Flux and Inlet Subcooling Degree

The Boiling Heat Transfer Characteristics of the Mixture HFO-1234yf/oil Inside a Micro-Fin Tube

Influence of Tube Diameter on Heat Transfer Characteristics of Refrigerant-Oil Mixture Flow Boiling in Metal-Foam Filled Tubes

The Correlations of Heat Transfer of Refrigerant-Oil Mixture Flow Boiling Inside Small Smooth Tubes

Influence of oil on flow condensation heat transfer of R410A inside 4.18 mm and 1.6 mm inner diameter horizontal smooth tubes

Heat Transfer Characteristics of R410A-oil Mixture Flow Boiling Inside a 7mm Straight Smooth Tube

Frictional Performance of Refrigerant-Oil Mixture Flow Boiling Inside Horizontal Smooth Tube

Influence of Lubricant Oil on Heat Transfer Performance of Refrigerant Flow Boiling Inside Small Diameter Tubes. Part II: Correlations

Experimental Study of Ammonia Flow Boiling in a Vertical Tube Bundle: Part 4 – Comparative Analysis