Abstract:This study investigates the strain-rate triggered PLC effect and fracture behavior of a rapidly solidified thin strip (TS) cast AA5182 alloy in comparison with those of direct chill (DC) counterparts. Higher cooling rates obtained via TS casting suppress the formation of phases in Al-Mg alloys and significantly enhance the matrix solute supersaturation beyond the equilibrium level, thereby impacting the interaction dynamics of mobile dislocations and solute atoms. This in turn affects the evolution of typical stress fluctuations in Al-Mg alloys, referred to as the Portevin-Le Chatelier (PLC) effect, occurring in specific strain rate-temperature domains, i.e., with type and characteristics dependent upon the microstructure. Tensile testing demonstrated a strain-rate dependent PLC effect, also aligning with the ductility trend in both negative and positive strain-rate sensitivity domains. The characteristics of PLC bands, as well as the magnitude of stress fluctuations, were shown to evolve with strain rate, facilitating distinct fracture mechanisms. In particular, the TS sample exhibited a higher strain rate sensitivity of the fracture mechanisms and PLC band characteristics and, thus, a narrower range of deformation rates for optimum ductility (attributed to increased solute in the matrix). Controlling the deformation rate to favor predominantly Type-B serrations and ensuring their stability with minimal fluctuations was shown to postpone necking and prevent material failure. The significance of rate sensitivity in alloys with reduced microsegregation is emphasized, suggesting the need for further exploration of mechanical properties.

Portevin-Le Châtelier Effect in a Wrought Ni–Co Based Superalloy

The Portevin-Le Chatelier Effect in Al-Mg Alloy Investigated by Infrared Pyrometry

The influence of additive manufacturing on Portevin-Le Châtelier (PLC) effect in Ni-Co-based superalloy

Experimental investigation of a Portevin-Le Chatelier band in Ni-Co-based superalloys in relation to ' precipitates at 500 C

Refining Micron-Sized Grains to Nanoscale in Ni-Co Based Superalloy by Quasistatical Compressive Deformation at High Temperature

Influence of γʹ precipitates on Portevin–Le Chatelier effect of NI-based superalloys

Investigation on Portevin-Le Chatelier Effect in a Ni-Co Based Superalloy Base on Digital Speckle Correlation

The Portevin-Le Chatelier (PLC) effect in an Al-Cu aluminum alloy fabricated by selective laser melting

3D Digital Image Correlation Investigation of PLC Effect in a New Ni–Co Base Superalloy

Influence of Γ′ Precipitates on the Critical Strain and Localized Deformation of Serrated Flow in Ni-based Superalloys

Effect of Solute Concentration on Portevin-Le Chatelier Effect in Al-Cu Alloys

Plastic Deformation Behaviors and Mechanical Properties of Advanced Single Crystalline CoNi-base Superalloys

Multiscale Analysis And Numerical Modeling Of The Portevin-Le Chatelier Effect

Effect of strain rate on microstructure evolution of a fine-grained γ + γ' Ni-Co-base superalloy during superplasticity

Copper effects on the microstructures and deformation mechanisms of CoCrFeNi high entropy alloys

Fracture behavior of a rapidly solidified thin-strip continuous cast AA5182 Al-Mg alloy with the Portevin-Le Chatelier effect under varying strain rates

Statistical analysis of serrated flows in CoNiV medium-entropy alloy

Doping Effects on the Stacking Fault Energies of Theγ' Phase in Ni-based Superalloys

Hot deformation behavior and flow stress modeling of a novel CoNi-based wrought superalloy

Numerical Analysis on the Spatiotemporal Characteristics of the Portevin-Le Chatelier Effect in Ti-12Mo Alloy

On the spatio-temporal characteristics of the Portevin-Le Chatelier effect in aluminium alloy AA5182: An experimental and numerical study