Digital Image Correlation Analysis of Uniform Deformation and Necking in Solid‐State Welded Nanocrystalline Aluminum via High‐Pressure Torsion
Laxman Bhatta,Isshu Lee,Roberto B. Figueiredo,Brian K. Bay,Megumi Kawasaki
DOI: https://doi.org/10.1002/adem.202400439
IF: 3.6
2024-04-30
Advanced Engineering Materials
Abstract:Solid‐state welding of Al 1043 sheets was achieved via high‐pressure torsion (HPT) processing to produce bulk nanostructured Al disks. A homogeneous nanostructure without segregation was observed, with grain sizes of ∽430‐470 nm. Miniature tensile testing, coupled with the digital image correlation (DIC) technique, was employed to determine the room‐temperature tensile deformation behavior, particularly the non‐uniform behavior with necking, of the HPT‐bonded ultrafine‐grained (UFG) aluminum, comparing it with annealed coarse‐grained counterpart. The HPT‐bonded UFG Al exhibited a large fraction of post‐necking strain, which is supported by the estimated high strain rate sensitivity value of m = 0.085, suggesting the delay of local necking leading to tensile fracture. Detailed DIC analysis revealed prolonged diffuse necking, thus delaying local necking, in the HPT‐bonded UFG Al, while the annealed samples show high fractions of local necking during the non‐uniform deformation. Moreover, the DIC data illustrated that local necking predominantly occurred at a limited neck zone, maintaining a plateau strain distribution at the out‐of‐neck zone throughout necking deformation towards tensile failure for both annealed and UFG aluminum. The DIC method offers an alternative means to demonstrate the transition in necking behaviors of materials by estimating the plastic lateral contraction exponent. This article is protected by copyright. All rights reserved.
materials science, multidisciplinary