Abstract:Steels are abundantly used in many areas because of their good formability and low price. Steels suffer from corrosion in aqueous environments with chloride ions. Corrosion of steels is also a serious problem for long-term usage of steel structures such as bridges and buildings. There are many studies focused on chloride ions. There are reports that metal cations have a tendency to inhibit the corrosion of steels in a chloride aqueous environment by forming a layer on the steel. The other important factor for corrosion of steels in an aqueous environment is temperature. The corrosion rate of metal in cold regions is expected to slow because of low temperature. A recent study on atmospheric exposure tests carried out in different places in Hokkaido, it has elucidated that the corrosion rate in the cold region is the same as in the warm region. However, it is not fully elucidated that temperature, especially below freezing point, and metal cations on corrosion behavior and distribution of active dissolution site. The purpose of this study is to investigate the influence of temperature and metal cations on thecorrosion behavior of steels. Steel sheets of 15 x 20 mm and 20 x 20 mm were used as specimens. Three solutions of 0.1 mM ZnCl 2 , 0.5 mM ZnCl 2 and 1.0 mM ZnCl 2 were used for examination of the effect of metal cations, and 20 mass % NaCl solution was used for examination of effect of temperature. After the tests, the morphology of specimens was examined by optical microscope and scanning electron microscope. After the wet/dry corrosion tests used 10 mL solutions droplets, corrosion products were formed on the specimens. The corrosion processes under NaCl and MgCl 2 were similar. Yellow corrosion products were firstly observed in the solution during the wet period. In the case of under ZnCl 2 , after the formation of oxide layer on the specimens the corrosion proceeded in localized areas. The color of almost half area of the exposed surface was light, which might indicate less corrosion occurred in the area. The initial corrosion stage of steel preferred to form a brown area in the center of the droplet. There are no similar corrosion products thatcan be observed in comparison to the samples under MgCl 2 and NaCl solutions. A lot of corrosion products and localized corroded areas were formed on specimens after being immersed at 273 K, while less corrosion products and homogenously corroded surface were observed on specimens after being immersed at 293K. The results indicated that corrosion morphology and preferentially corroded area were changed with the kind of metal cation and temperature.

Effects of Varying Temperatures and Alkalinities on the Corrosion and Heavy Metal Release from Low-Lead Galvanized Steel

Effects of Chloride and Humic Acid on Iron Release in Water Distribution System

Change regularity of water quality parameters in leakage flow conditions and their relationship with iron release.

Metal-release Potential from Iron Corrosion Scales under Stagnant and Active Flow, and Varying Water Quality Conditions.

Effects of Major Anions on Iron Release in Drinking Water Supply System

Influence Factors of Initial Internal Corrosion of Grey Cast Iron Pipes in Water Distribution System

Study on the Occurrence of Typical Heavy Metals in Drinking Water and Corrosion Scales in a Large Community in Northern China.

Effects of chloride on corrosion scale compositions and heavy metal release in drinking water distribution systems

Effect of Ca2+ and Mg2+ on Corrosion and Scaling of Galvanized Steel Pipe in Simulated Geothermal Water

Effect of Alloying on Sn-Zn Lead-free Solder Corrosion Resistance

Corrosion and Scaling of the Galvanized Steel Pipe in Flowing Geothermal Water

Effects of Ambient Temperature and State of Galvanized Layer on Corrosion of Galvanized Steel in High-Humidity Neutral Atmosphere

Microelectrode investigation on the corrosion initiation at lead-brass galvanic interfaces in chlorinated drinking water.

Review Study on the Accumulation and Release of Trace Metal Elements on Aluminum Containing Sediments in Drinking Water Distribution System

Characteristics of Iron Corrosion Scales and Water Quality Variations in Drinking Water Distribution Systems of Different Pipe Materials.

Corrosion Behavior of the Galvanized Steel Sheet in Different Medium

Effect of pH, Temperature, Dissolved Oxygen, and Flow Rate of Overlying Water on Heavy Metals Release from Storm Sewer Sediments

Manganese Release from Corrosion Products of Cast Iron Pipes in Drinking Water Distribution Systems: Effect of Water Temperature, Ph, Alkalinity, SO42- Concentration and Disinfectants

Effect of Overlying Water Ph, Temperature, and Hydraulic Disturbance on Heavy Metal and Nutrient Release from Drinking Water Reservoir Sediments.

Influence of Metal Cation and Temperature on Localized Corrosion Behavior of Steels in Aqueous Environments

Aging Process of Cadmium, Copper, and Lead under Different Temperatures and Water Contents in Two Typical Soils of China