Abstract:A novel micro-electromechanical systems inertial switch based on non-silicon surface micromachining technology has been designed, fabricated and characterized in the present work. Compared with the traditional inertial switch, a compliant cantilever beam as a stationary electrode has been proposed to prolong the contact time, which can realize sufficient elastic deformation during the contact between the electrodes. The dynamic contact process is analyzed theoretically and the corresponding mechanical impact mechanism is also explained. To investigate the contact-enhancing mechanism of the cantilever beam, the switch applied half-sine acceleration with various amplitudes in the sensitive direction is simulated with ANSYS software. The dynamic simulation results confirm the contact-enhancing mechanism described by the theoretical analysis and it is shown that the contact time (i.e., the switch-on time) can be prolonged effectively by utilizing the elastic deformation of the cantilever beam and increased with the applied accelerations. The inertial switch is successfully fabricated by electroplating and sacrificial layer processes technologies. The prototype has been characterized by dropping hammer experiment. The test results indicate that the contact effect is improved significantly and the contact time is ∼80 µs under the 297 g acceleration, and the maximum value is ∼410 µs for the 672 g acceleration amplitude, which is in general accordance with the simulated results. The mechanical contact between the cantilever beam and the proof mass is evaluated following thousands of impacts. The scanning electron micrographs of the contact surfaces indicate that the all-metal switch still keeps a good mechanical property after suffering the hot contact, and the contact resistance is also stable.

A Restoring Force Boosting Structure with Flexible Stiction Recovery Electrode for MEMS Relays/Switches

Design and Experimental Validation of A Restoring Force Enhanced Rf Mems Capacitive Switch with Stiction-Recovery Electrodes

Multi-actuated Mechanism Design Considering Structure Flexibility Using Correlated Performance Reinforcing

Electrostatic Comb-Drive Actuator for Mems Relays/Switches with Double-Tilt Comb Fingers and Tilted Parallelogram Beams

A Two-Stage Magnetically Enhanced Buoyancy Adjustment Actuator Based on Dielectric Elastomer

Multi-physics Analysis of an Electrostatically Actuated Microcantilever in Viscous Fluids

Design and Fabrication of a Novel MEMS Relay with Low Actuation Voltage.

Tunable Actuation of Dielectric Elastomer by Electromechanical Loading Rates

Low Voltage, High Speed and Small Area In-Plane MEMS Switch

A Magnet‐Driven Soft Bistable Actuator

Experiment and simulation study of instability of a novel electrostatic MEMS relay

A New Four States High Deflection Low Actuation Voltage Electrostatic Mems Switch for RF Applications

Vacuum Bouncing Dynamics Dominated by Van Der Waals Forces in Mems Relays

Improved Model of Residual Stress on Top Electrode Membrane of Fixed-Fixed Beam RF MEMS Switches

High-power mems relay array with improved reliability and consistency

Rigid Electrodes Enhance the Strain and Force Output of Peano-HASEL Actuators

A laterally-driven micromachined inertial switch with a compliant cantilever beam as the stationary electrode for prolonging contact time

Electromechanical bistable behavior of a novel dielectric elastomer actuator

Experimental analysis of a low controlling voltage tri-electrode MEMS electrostatic actuator for array applications

A Planar Single-Actuator Bi-Stable Mechanical/Electrical Switch

Stress Suppression Design for Radiofrequency Microelectromechanical System Switch Based on a Flexible Substrate