Abstract:Super-knock has been a significant obstacle for the development of highly turbocharged (downsized) gasoline engines with spark ignition, due to the catastrophic damage super-knock can cause to the engine. According to previous research by the authors, one combustion process leading to super-knock may be described as hot-spot induced pre-ignition followed by deflagration which can induce detonation from another hot spot followed by high pressure oscillation. The sources of the hot spots which lead to pre-ignition (including oil films, deposits, gas-dynamics, etc.) may occur sporadically, which leads to super-knock occurring randomly at practical engine operating conditions. In this study, a spark plasma was used to induce preignition and the correlation between super-knock combustion and the thermodynamic state of the reactant mixture was investigated in a four-cylinder production gasoline engine. The engine experiments were complemented by rapid compression machine (RCM) experiments of iso-octane and air which also used a spark plasma to investigate the fundamental physical and chemical mechanisms of super-knock. For the engine experiments, at low-speed high-load conditions, early spark timing was used to systematically induce preignition in the range of spark timing from 8 to -50 degrees CA ATDC in increments of 3 degrees CA. The intake pressure of the fresh air charge was set at 1, 1.3, 1.6 and 1.9 bar, and for each intake air pressure, the intake temperature was set at 20 and 60 degrees C. The results show early spark ignition could be used to trigger pre-ignition and to induce super-knock when the mixture thermodynamic state was above a critical condition. At a constant air temperature and high intake pressure, advancing the spark timing caused transitions from normal combustion to knocking conditions, to super-knocking conditions and then back to knocking conditions and to normal combustion. The transition between knocking conditions was well correlated with the thermodynamic state at the start of the in-cylinder pressure oscillations associated with knock. At a constant temperature and naturally aspirated conditions, no matter how advanced the spark timing was, only slight knock was observed, which indicates the thermodynamic state dominates the determination of knocking or non-knocking conditions. An energy density-pressure-temperature (E-P-T) diagram was developed to define super-knock, knock and normal combustion criteria. For the RCM experiments using isooctane at stoichiometric conditions with air dilution, a spark plasma was used to simulate pre-ignition. Three compression ratios were used to create different end of compression (EOC) temperatures. For each T EOC, with increasing EOC pressure, the combustion process also transitioned from normal combustion with flame propagation, to sequential end-gas auto-ignition with pressure oscillations and then to detonation with severe pressure oscillations. The combustion processes observed in the RCM experiments and the thermodynamic states were similar to the state conditions at the start of the pressure oscillations of the constant temperature and high intake pressure engine experiments. The results indicate RCM studies can be used to investigate the physical and chemical mechanisms of super-knock and E-P-T diagrams can be used to predict and distinguish super-knock from other combustion modes.

Quantitative evaluation of n-butane concentration on knock severity of a natural gas heavy-duty SI engine

Performance, combustion and knock assessment of a high compression ratio and lean-burn heavy-duty spark-ignition engine fuelled with n-butane and liquefied methane gas blend

Numerical Investigation of Methane Number and Wobbe Index Effects in Lean-Burn Natural Gas Spark-Ignition Combustion

Knock analysis of bio-butanol in TISI engine based on chemical reaction kinetics

Statistical Quantification of Knock With Spark Ignition and Pre-Chamber Jet Ignition in a Light Duty Gasoline Engine

Spray behavior of butanol-diesel and numerical simulation of mixture formation with engine

Numerical investigation on knock characteristics and mechanism of large-bore natural gas dual-fuel marine engine

An exploratory study of knock intensity in a large-bore heavy-duty methanol engine

Knock Prediction for Dual Fuel Engines by Using a Simplified Combustion Model.

Numerical study on the combustion and emission characteristics of a direct injection natural gas engine ignited by diesel/n-butanol blends

Experimental and model-based analysis of combustion and auto-ignition of gasoline and three surrogate fuels in a single-cylinder research engine operated under knocking conditions

Implementation and Parameter Analysis of the Knock Phenomenon of a Marine Dual-Fuel Engine Based on a Two-Zone Combustion Model

The knock study of high compression ratio SI engine fueled with methanol in combination with different EGR rates

Numerical investigation on combustion regulation for a stoichiometric heavy-duty natural gas engine with hydrogen addition considering knock limitation

Experimental study of knock combustion and direct injection on knock suppression in a high compression ratio methanol engine

The sensitivity of pressure-based knock threshold values to alternative fuels: A comparison of methanol vs. gasoline

Effects of charge motion on knock and thermal efficiency under high load condition of a heavy-duty natural gas engine

Effects of Chamber Geometry, Hydrogen Ratio and EGR Ratio on the Combustion Process and Knocking Characters of a HCNG Engine at the Stoichiometric Condition

Effects of charge motion on knocking combustion under boosted high load condition of a medium-duty gasoline engine

Highly Turbocharged Gasoline Engine and Rapid Compression Machine Studies of Super-Knock

Numerical comparative study on knocking combustion of high compression ratio spark ignition engine fueled with methanol, ethanol and methane based on detailed chemical kinetics