Tailoring the Crystalline Morphology and Mechanical Property of Olefin Block Copolymer Via Blending with a Small Amount of UHMWPE
Yongsheng Zhao,Yanling Zhu,Guopeng Sui,Feng Chen,Qiang Fu
DOI: https://doi.org/10.1016/j.polymer.2016.12.025
IF: 4.6
2016-01-01
Polymer
Abstract:In this study, the crystalline morphology and mechanical property of Olefin Block Copolymer (OBC) were tailored by adding a small amount (up to 10 wt%) of ultrahigh molecular weight polyethylene (UHMWPE). To do this, OBC and UHMWPE was solution blended first and then subjected to compression molding or injection molding, respectively. It was found that a small quantity of UHMWPE (0.5 wt%, 1 wt %) can be fully mixed with OBC, while phase separation occurs when UHMWPE content is higher than 2.5 wt%, as suggested by SEM and DSC results. For compression molded samples, an obvious increase of Young's modulus from 12 MPa to 22 MPa while maintaining the good elasticity of OBC was observed as the content of UHMWPE is less than 2.5 wt% (in the phase miscible range). With further increasing of UHMWPE content to 10 wt%, only slightly increased Young's modulus is seen. Thus the miscibility between OBC and UHMWPE plays an important role in determining the mechanical property for compression molded samples. However, a continuous increase of Young's modulus was observed with the increase of UHMWPE content for samples obtained via injection molding, with a slight increase (from 23 MPa to 40 MPa) as the content of UHMWPE is less than 2.5 wt%, while with a large increase (from 40 MPa to 156 MPa) as the content of UHMWPE increases from 2.5 wt% to 10 wt, accompanied with a greatly decrease of elongation (from 1100% to 50%). Even elastomer-to-plastic transition takes place when the content of UHMWPE is large (5 wt%, 10 wt%). Structural analysis of injection-molded samples shows that shish-kebab-like structures can be successfully induced as addition of UHMWPE along with gradually increased crystal orientation. It was interesting to find that small-addition of UHMWPE favors increased tie-effect due to the miscibility between OBC and UHMWPE, which is helpful to the elasticity retaining as well as strength enhancement, while large-addition of UHMWPE gives rise to phase separation and mixed shish-kebabs (OBC/UHMWPE hybrid shish-kebabs and UHMWPE homo-shish-kebabs), leading to elastomer-to-plastic transition. (C) 2016 Elsevier Ltd. All rights reserved.