Abstract:High efficiency thin-film silicon (Si) solar cells were prepared on flexible substrates by the plasma-enhanced chemical vapor deposition method. To improve their performance, the microstructural, electrical, and optical properties of the core component layers including the metal rear reflectors, p- and n-type doped layers, and intrinsic absorber layers were controlled sophistically. To enable the use of flexible substrates with low heat resistance as well as to enhance light-scattering properties, nanotextured rear reflectors with a Ag/Al:Si bilayer structure were developed by dc magnetron sputtering at a low substrate temperature of below 150 degrees C. Highly crystalline n-doped seed layers (which effectively eliminate a defect-dense amorphous region formed in the initial growth stage of intrinsic nanocrystalline silicon (nc-Si:H) absorber layers) and p-type wide-bandgap nanocrystalline silicon carbide (nc-SiC:H) window layers (which reduce the parasitic absorption loss in the short wavelength region and increase the open circuit voltage (Voc)) were successfully applied to enhance the performance characteristics of the solar cells. Through the combination of the developed core component layers, high conversion efficiencies of 8.84% (V-oc = 0.53 V, J(sc) = 25.28 mA/cm(2), and fill factor (FF) = 0.66, where J(sc) is the short circuit current) and 7.48% (V-oc = 0.50 V, J(sc) = 21.07 mA/cm(2), and FF = 0.71) were obtained for nc-Si:H solar cells fabricated on stainless steel (SUS) and polyimide substrates, respectively, at a low substrate temperature of below 150 degrees C. Flexible a-Si:H/nc-Si:H double-junction solar cells fabricated on SUS substrates showed a high conversion efficiency of 11.46% (V-oc = 1.38 V, J(sc) = 11.53 mA/cm(2), and FF = 032) when the nc-Si:H solar cells developed in this study were applied as a bottom cell.

Short-circuit Current Density and Fill Factor Improvement by Optimizing In2O3:H and Metal Back Reflector Layers for P-I-n A-Sige:H Thin Film Solar Cells

Highly Efficient Silicon Heterojunction Solar Cells with ZnO:Al Transparent Electrode and Transition Metal Doped Indium Oxide Interfacial Layer

Enhanced Crystallization and Optimized Morphology of Perovskite through Doping Indium-Based Metal-Organic Assembly: Achieving Significant Solar Cell Efficiency Enhancements

Improved performance of GaAs-based micro-solar cell with novel polyimide/SiO 2 /TiAu/SiO 2 structure

Thin heterojunction a-Si:H photovoltaic cell design with no doped a-Si:H layers

Beyond 25% efficient crystalline silicon heterojunction solar cells with hydrogenated amorphous silicon oxide stacked passivation layers for rear emitter

Improving the performance of high-efficiency silicon heterojunction solar cells through low-temperature deposition of an i-a-Si:H anti-epitaxial buffer layer

Optimum Design And Preparation Of A-Si/A-Si/A-Sige Triple-Junction Solar-Cells

Optimum design and preparation of<i>a</i>‐Si/<i>a</i>‐Si/<i>a</i>‐SiGe triple‐junction solar cells

The advantages of employing i-a-SiOX:H as a buffer layer in Hydrogenated Amorphous Silicon Oxide solar cells

Improved Surface Passivation by Wet Texturing, Ozone‐Based Cleaning, and Plasma‐Enhanced Chemical Vapor Deposition Processes for High‐Efficiency Silicon Heterojunction Solar Cells

Light management in hydrogenated amorphous silicon germanium solar cells

Simulation and experimental study of a novel bifacial structure of silicon heterojunction solar cell for high efficiency and low cost

Significant Improvement of Passivation Performance by Two-Step Preparation of Amorphous Silicon Passivation Layers in Silicon Heterojunction Solar Cells*

Balance of efficiency and stability of silicon heterojunction solar cells

PHOTOELECTRIC STRUCTURE DESIGN OF HIGH EFFICIENCY AMORPHOUS SILICON GERMANIUM SOLAR CELL BASED ON LIGHT MANAGEMENT AND BAND GAP PROFILING

Power conversion efficiency of 25.26% for silicon heterojunction solar cell with transition metal element doped indium oxide transparent conductive film as front electrode

Improved Power Conversion Efficiency in Radial Junction Thin Film Solar Cells Based on Amorphous Silicon Germanium Alloys

Performance Enhancement of Thin-Film Silicon Solar Cells by Development of Core Component Layers

High-Mobility Hydrogenated Fluorine-Doped Indium Oxide Film for Passivating Contacts c-Si Solar Cells

Nanocrystalline‐silicon hole contact layers enabling efficiency improvement of silicon heterojunction solar cells: Impact of nanostructure evolution on solar cell performance