Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Deposition of Wet Microparticles on a Fiber: Effects of Impact Velocity and Initial Spin

Mechanistic Studies of Initial Deposition of Fine Adhesive Particles on a Fiber Using Discrete-Element Methods

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

A many-body dissipative particle dynamics study of eccentric droplets impacting inclined fiber

Numerical simulation of non-spherical microparticles' deposition on single fiber

Normal impact of adhesive microparticles with a film/substrate system: A numerical study

Research on the Interaction of Three Contact Fibers in the Fiber Suspensions

Effect of the Rolling Friction Coefficient on Particles’ Deposition Morphology on Single Fibre

Investigation of the interactions between two contact fibers in the fiber suspensions

Some Considerations for Measuring the Collisional Dissipation Rate of Flexible Fibers

Electrically-enhanced Deposition of Fine Particles on a Fiber: A Numerical Study Using DEM

Numerical simulations of the normal impact of adhesive microparticles with a rigid substrate

The effect of surface roughness on normal restitution coefficient, adhesion force and friction coefficient of the particle-wall collision

Dispersion phenomena of liquid droplet impacting on the single fiber with different wettabilities

Effects of Fiber Diameter and Tribotest Conditions on Nonlubricated Frictional Behavior of a Microsized Metal Fiber

The effect of incident angle on the rebound behavior of micro-particle impacts

Retention amount and flow behavior of droplets on cross‐fiber intersections during coalescence separation

Deposition and alignment of fiber suspensions by dip coating

Role Of Hydrodynamic Drag On Microsphere Deposition And Re-Entrainment In Porous Media Under Unfavorable Conditions

Experimental research on the settling property of slender fiber particles under the influence of multiple factors

Research on wearing behavior of fibers in a rotor by numerical simulation and experimental verification