Abstract:Opportunities exist for effective coal combustion additives that can reduce the carbon content of pulverized fuel ash (PFA) to below 6%, thereby making it saleable for filler/building material applications without the need for postcombustion treatment. However, with only limited combustion data currently available for the multitude of potential additives, catalytic performance under pulverized fuel (PF) boiler conditions has received relatively little attention. For the first time, this paper therefore compares the reactivity of catalyzed bituminous coal chars from thermogravimetric analysis (TGA) with those generated by devolatilization in a drop tube furnace (DTF). The principal aim was to explore the fundamental chemistry behind the chosen additives’ relative reactivities. Accordingly, all eight of the investigated additives increased the TGA burnout rate of the TGA and DTF chars, with most of the catalysts demonstrating consistent reactivity levels across chars from both devolatilization methods. Copper(I) chloride, silver chloride, and copper nitrate were thus identified as the most successful additives tested, but it proved difficult to establish a definitive reactivity ranking. This was largely due to the use of physical mixtures for catalyst dispersion, the relatively narrow selection of additives examined, and the inherent variability of the DTF chars. Nevertheless, one crucial exception to normal additive behavior was discovered, with copper(I) chloride perceptibly deactivating during devolatilization in the DTF, even though it remained the most effective catalyst tested. As a prolonged burnout at over 1000 °C was required to replicate this deactivation effect on the TGA, the phenomenon could not be detected by typical testing procedures. Subsequently, a comprehensive TGA study showed no obvious relationship between the catalyst-induced reductions in the reaction’s apparent activation energy and the samples’ recorded burnout rates. Although copper(I) chloride did generate a diffusion controlled reaction regime at a lower temperature than the other additives. Furthermore, only the thermally labile iron(III) chloride appeared capable of exerting a catalytic effect under mass transfer controlled combustion regimes, signifying that the physical state of the catalyst could be an important factor during PF combustion.

Catalytic Effect of Metal Chloride Additives on the Volatile Gas Release Characteristics for High-Temperature Lignite Pyrolysis

Catalytic Effect of Metal Chlorides on Coal Pyrolysis and Gasification Part I. Combined TG-FTIR Study for Coal Pyrolysis

Influence Of Metal Additives On Pyrolysis Behavior Of Bituminous Coal By Tg-Ftir Analysis

Metal Chloride Influence on Syngas Component During Coal Pyrolysis in Fixed-Bed and Entrained Flow Drop-Tube Furnace

Catalytic effect and kinetic mechanism of alkali metal carbonates on the reduction reaction of biochar with iron oxide

Kinetics and Mechanisms of Metal Chlorides Catalysis for Coal Char Gasification with CO2

Influence of Temperature and Ca(OH)2 on Releasing Tar and Coal Gas During Lignite Coal Pyrolysis and Char Gasification

Experimental Study on Steam Gasification of Lignite Char Catalyzed by Several Metals

Catalytic Effect of Alkali Metals on the Gasification Dissolution Reaction and Deep Reaction Behavior of Metallurgical Cokes.

Reactivity and catalytic effect of coals during combustion: Thermogravimetric analysis

Catalytic effect of metal salts on deoxygenation and aromatization reaction during pressurized pyrolysis of corncob waste at mild temperatures

Evaluating the Combustion Reactivity of Drop Tube Furnace and Thermogravimetric Analysis Coal Chars with a Selection of Metal Additives

Catalytic performance of activated lignite chars on biomass tar cracking

Effect of temperature and gasification gas from char on the reactions of volatiles generated from rapid pyrolysis of a low rank coal

A TG-FTIR Study on Catalytic Pyrolysis of Coal

Enhancing oil shale pyrolysis using metal-doped carbon quantum dot catalysts: A comprehensive behavioral, kinetic, and mechanistic analysis

Mild modification of lignin pyrolysis vapors by metal oxide catalysts: A comparative study with molecular sieve catalysts

Catalytic effect of alkali metal in biomass ash on the gasification of coal char in CO2

Pyrolysis Characteristics of Hailar Lignite in the Presence of Polyvinyl Chloride: Products Distribution and Chlorine Migration

Cascade Chain Catalysis of Coal Combustion by Na–Fe–Ca Composite Promoters from Industrial Wastes

Effect of Catalyst Loadings on the Gasification Reactivity of a Lignite Char with Steam