Abstract:Opportunities exist for effective coal combustion additives that can reduce the carbon content of pulverized fuel ash (PFA) to below 6%, thereby making it saleable for filler/building material applications without the need for postcombustion treatment. However, with only limited combustion data currently available for the multitude of potential additives, catalytic performance under pulverized fuel (PF) boiler conditions has received relatively little attention. For the first time, this paper therefore compares the reactivity of catalyzed bituminous coal chars from thermogravimetric analysis (TGA) with those generated by devolatilization in a drop tube furnace (DTF). The principal aim was to explore the fundamental chemistry behind the chosen additives’ relative reactivities. Accordingly, all eight of the investigated additives increased the TGA burnout rate of the TGA and DTF chars, with most of the catalysts demonstrating consistent reactivity levels across chars from both devolatilization methods. Copper(I) chloride, silver chloride, and copper nitrate were thus identified as the most successful additives tested, but it proved difficult to establish a definitive reactivity ranking. This was largely due to the use of physical mixtures for catalyst dispersion, the relatively narrow selection of additives examined, and the inherent variability of the DTF chars. Nevertheless, one crucial exception to normal additive behavior was discovered, with copper(I) chloride perceptibly deactivating during devolatilization in the DTF, even though it remained the most effective catalyst tested. As a prolonged burnout at over 1000 °C was required to replicate this deactivation effect on the TGA, the phenomenon could not be detected by typical testing procedures. Subsequently, a comprehensive TGA study showed no obvious relationship between the catalyst-induced reductions in the reaction’s apparent activation energy and the samples’ recorded burnout rates. Although copper(I) chloride did generate a diffusion controlled reaction regime at a lower temperature than the other additives. Furthermore, only the thermally labile iron(III) chloride appeared capable of exerting a catalytic effect under mass transfer controlled combustion regimes, signifying that the physical state of the catalyst could be an important factor during PF combustion.

Influence Of Metal Additives On Pyrolysis Behavior Of Bituminous Coal By Tg-Ftir Analysis

Catalytic Effect of Metal Chloride Additives on the Volatile Gas Release Characteristics for High-Temperature Lignite Pyrolysis

Molecular Reaction Dynamics Simulation of Pyrolysis Mechanism of Typical Bituminous Coal Via ReaxFF

A TG-FTIR Study on Catalytic Pyrolysis of Coal

Catalytic Effect of Metal Chlorides on Coal Pyrolysis and Gasification Part I. Combined TG-FTIR Study for Coal Pyrolysis

Study on lightening of coal tar with metal oxide supported γ-Al2O3 catalyst

Effects of Fe2O3 addition on the thermoplasticity and structure of coking coal matrix during thermoplastic stage of pyrolysis

Catalytic Effect of Alkali Metals on the Gasification Dissolution Reaction and Deep Reaction Behavior of Metallurgical Cokes.

Metal Chloride Influence on Syngas Component During Coal Pyrolysis in Fixed-Bed and Entrained Flow Drop-Tube Furnace

The Catalytic Effect from Alkaline Elements on the Tar-Rich Coal Pyrolysis

Evaluating the Combustion Reactivity of Drop Tube Furnace and Thermogravimetric Analysis Coal Chars with a Selection of Metal Additives

Effects of Iron Minerals Embedded in Coal with Different Methods on the Distribution of Pyrolysis Products and the Gasification Reactivity of Its Pyrolysis Char

Catalytic Cracking and Catalyst Deactivation/regeneration Characteristics of Fe-loaded Biochar Catalysts for Tar Model Compound

Catalytic mechanism of Na on coal pyrolysis-derived carbon black formation: Experiment and DFT simulation

Influence of Huainan Bituminous Coal Ash on Coal Pyrolysis

Catalytic Influence of Iron Oxide (fe2o3) on Coal Pyrolysis and Char Combustion at Various Temperatures

Understanding the Effect of Different Biomass Ash Additions on Pyrolysis Product Distribution, Char Physicochemical Characteristics, and Char Gasification Reactivity of Bituminous Coal

Effects of Various Additives on the Pyrolysis Characteristics of Municipal Solid Waste

Influence of Calcium Chloride on the Fine Particulate Matter Formation During Coal Pyrolysis

Investigation of Pyrolysis and Mild Oxidation Characteristics of Tar-Rich Coal via Thermogravimetric Experiments.

Influence of alkali metal Na on coal-based soot production