Abstract:A single-phase grounding fault often occurs in 10 kV distribution networks, seriously affecting the safety of equipment and personnel. With the popularization of urban cables, the low-resistance grounding system gradually replaced arc suppression coils in some large cities. Compared to arc suppression coils, the low-resistance grounding system features simplicity and reliability. However, when a high-resistance grounding fault occurs, a lower amount of fault characteristics cannot trigger the zero-sequence protection action, so this type of fault will exist for a long time, which poses a threat to the power grid. To address this kind of problem, in this paper, a hybrid grounding system combining the low-resistance protection device and fully controlled power module is proposed. During a low-resistance grounding fault, the fault isolation is achieved through the zero-sequence current protection with the low-resistance grounding system itself, while, during a high-resistance grounding fault, the reliable arc extinction is achieved by regulating the neutral-point voltage with a fully controlled power module. Firstly, this paper introduces the principles, topology, and coordination control of the hybrid grounding system for active voltage arc extinction. Subsequently, a dual-loop-based control method is proposed to suppress the fault phase voltage. Furthermore, a faulty feeder selection method based on the Kepler optimization algorithm and convolutional neural network is proposed for the timely removal of permanent faults. Lastly, the simulation and HIL-based emulated results verify the rationality and effectiveness of the proposed method.

Control of Smart Transformer Under Single-Phase to Ground Fault Condition

Continuous Operation of Smart Transformer-fed Distribution Grid with Single-phase Faults

Smart Transformer-Based Single Phase-To-Neutral Fault Management

Management and Control of Smart Transformer-Fed LV Distribution Networks During Grid Faults

Neutral Current Reduction Control For Smart Transformer Under The Imbalanced Load In Distribution System

Neutral Current Optimization Control for Smart Transformer-Fed Distribution System under Unbalanced Loads

High Power Quality Voltage Control of Smart Transformer-Fed Distribution Grid.

Control Of Smart Transformer In Different Electric Grid Configurations

Single‐phase Grouding Fault Analysis and Control Scheme of Transformerless Flexible Multistate Switch

Control strategy of on-load tap-changer based on digital substation

Operation and Control of the Smart Transformer in Meshed and Hybrid Grids: Choosing the Appropriate Smart Transformer Control and Operation Scheme

Grid-Forming Control of Smart Solid-State Transformer in Meshed Network

Smart transformer-based medium voltage grid support by means of active power control

Flexible Control Structure of a Smart Transformer for Universal Operation

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

Investigation on Common-Mode Voltage Suppression in Smart Transformer-Fed Distributed Hybrid Grids

Control Strategy for Single-Phase Open-Circuit Operation of a Modular Solid-State Transformer

Fault control and line protection strategy for LVDC microgrids based on modified high-frequency-link DC solid state transformer

Overload Operation of LV-Side Inverter in Smart Transformer

Protection and Management of Internal Faults in Modular Smart Transformer

Neutral-Point Voltage Regulation and Control Strategy for Hybrid Grounding System Combining Power Module and Low Resistance in 10 kV Distribution Network