Abstract:Non-equiatomic high entropy alloys (HEAs) and medium entropy alloys (MEAs) are expected to have the potential to exhibit good mechanical properties due to abundant composition designs compared to equiatomic alloys. It has been reported that an equiatomic CoCrNi MEA shows better strength-ductility balance than CoCrFeMnNi HEA, and there is a possibility that the mechanical properties can be further improved by changing chemical composition. Among the constituent elements, cobalt (Co) has the effect of decreasing stacking fault energy (SFE). In this study, we clarified the effect of Co-content on mechanical properties of non-equiatomic Co–Cr–Ni MEAs with different amounts of Co through investigating deformation behaviors and deformation microstructures. Cox(CrNi)(100−x) (x = 20 (Co20), 40 (Co40), 60 (Co60) at%) MEAs were processed to very high plastic strains by high-pressure torsion (HPT) and subsequently annealed under proper conditions to obtain FCC single-phase and uniform fine grain sizes. Mechanical properties of the specimens with fully recrystallized microstructures were characterized by tensile tests at room temperature. Their deformed microstructures at different tensile strain levels were observed by electron microscopy. The result of the tensile tests showed that the work-hardening rate was enhanced with increasing the Co-content although early fracture before reaching plastic instability condition occurred in Co60. Planar slip of dislocations and deformation twinning were observed in Co20 (SFE = 30 mJ/m2), while, in addition to them, deformation-induced martensitic transformation to HCP ε-martensite was observed in Co40 having lower SFE (SFE = 10 mJ/m2), leading to higher work-hardening rate. By increasing Co-content (decreasing SFE) further, phase fraction of ε-martensite greatly increased in Co60 (SFE = 0 mJ/m2) compared with Co40, and early fracture occurred due to stress concentration at intersects between martensite and grain boundaries. The present results suggested that the mechanical properties of the present materials could be effectively designed by controlling the SFE.

Effects of Pre-Compression on the Hardness of CoCrFeNiMn High Entropy Alloy Based an Asymmetrical Yield Criterion

Hardening-softening of Al 0.3 CoCrFeNi high-entropy alloy under nanoindentation

Compressive deformation behavior of CrMnFeCoNi high-entropy alloy

A micromechanical study on the effects of precipitation on the mechanical properties of CoCrFeMnNi high entropy alloys with various annealing temperatures

Dynamic Mechanical Behavior and Microstructure of the Al 0.1 CoCrFeNiTi x High‐Entropy Alloys

Dynamic impact behavior and deformation mechanisms of Cr26Mn20Fe20Co20Ni14 high-entropy alloy

Effects of Annealing on Hardness, Yield Strength and Dislocation Structure in Single Crystals of the Equiatomic Cr-Mn-Fe-Co-Ni High Entropy Alloy

Effect of Strain Rate on Deformation Behavior of AlCoCrFeNi High-Entropy Alloy by Nanoindentation

Effect of Thermomechanical Processing on Microstructure and Mechanical Properties of CoCrFeNiMn High Entropy Alloy

Strain Rate Effects on the Mechanical Properties of an AlCoCrFeNi High-Entropy Alloy

Strain softening observed during nanoindentation of equimolar-ratio Co–Mn– Fe–Cr–Ni high entropy alloy

Mechanical properties and microstructure of the Al0.3CoCrFeNiTi0.3 high entropy alloy under dynamic compression

Microstructure and Compressive Deformation Behavior of As-Cast CrFeCoNiCux High Entropy Alloys

Atomistic Simulations of Compressive Response and Deformation Mechanisms of Body-Centered-cubic AlCrFeCoNi High-Entropy Alloys

The Effect of Cu and Mn Elements on the Mechanical Properties of Single-Crystal CoCrFeNi-based High-Entropy Alloy under Nanoindentation

Deformation Behavior and Strengthening Effects of an Eutectic AlCoCrFeNi2.1 High Entropy Alloy Probed by In-Situ Synchrotron X-ray Diffraction and Post-Mortem EBSD

Effect of Coherent Nanoprecipitate on Strain Hardening of Al Alloys: Breaking through the Strength-Ductility Trade-Off

Effect of Cobalt-Content on Mechanical Properties of Non-Equiatomic Co–Cr–Ni Medium Entropy Alloys

Effect of deformation heterogeneity on development of geometrically necessary dislocation density in heterogeneous-structured CrMnFeCoNi high-entropy alloy

Molecular simulation of microstructure evolution and plastic deformation of nanocrystalline CoCrFeMnNi high-entropy alloy under tension and compression

Investigation of mechanical behavior, constitutive modeling, and fracture criteria for as-cast Al0.3CoCrFeNi high entropy alloy