Abstract:Gallium nitride (GaN)-based high electron mobility transistor (HEMT) power devices have demonstrated great potential applications due to high current density, high switching speed, and low ON-resistance in comparison to the established silicon (Si)-based semiconductor devices. These superior characteristics make GaN HEMT a promising candidate for next-generation power converters. Many of the early GaN HEMTs are devices with Schottky gate, which suffer a high gate leakage and a small gate swing. By inserting an insulator under gate metal, the MIS-HEMT is highly preferred over the Schottky-gate HEMT for high-voltage power switche, owing to the suppressed gate leakage and enlarged gate swing. However, the insertion of the gate dielectric creates an additional dielectric/(Al) GaN interface that presents some great challenges to AlGaN/GaN MIS-HEMT, such as the threshold voltage (Vth) hysteresis, current collapse and the reliability of the devices. It has been reported that the poor-quality native oxide (GaOx) is detrimental to the dielectric/(Al) GaN interface quality that accounted for the Vth instability issue in the GaN based device. Meanwhile, it has been proved that in-situ plasma pretreatment is capable of removing the surface native oxide. On the other hand, low power chemical vapor deposition (LPCVD)-Si3N4 with free of plasma-induced damage, high film quality, and high thermal stability, shows great potential applications and advantages as a choice for the GaN MIS-HEMTs gate dielectric and the passivation layer. In this work, an in-situ pre-deposition plasma nitridation process is adopted to remove the native oxide and reduce surface dangling bonds prior to LPCVD-Si3N4 deposition. The LPCVD-Si3N4/GaN/AlGaN/GaN MIS-HEMT with a high-quality LPCVD-Si3N4/GaN interface is demonstrated. The fabricated MIS-HEMT exhibits a very-low Vth hysteresis of 186 mV at VG-sweep=(-30 V, +24 V), a high breakdown voltage of 881 V, with the substrate grounded. The hysteresis of our device at a higher positive end of gate sweep voltage (VG +20 V) is the best to our knowledge. Switched off after an off-state VDS stress of 400 V, the device has a dynamic on-resistance Ron only 36% larger than the static Ron.

A GaN RB-MISHEMT with a Schottky–MIS Hybrid Drain and an Al0−0.50Ga1−0.50N/GaN Heterojunction

A GaN-based RB-MISHEMT with Schottky-MIS Hybrid Drain and TUG-AlGaN Barrier Layer

1.3 Kv Reverse-Blocking AlGaN/GaN MISHEMT with Ultralow Turn-On Voltage 0.25 V

Reverse-blocking AlGaN/GaN Normally-off MIS-HEMT with Double-Recessed Gated Schottky Drain

A Non-Ohmic Normally-off GaN RB-MISHEMT Featuring a Gate-Controlled Schottky Tunnel Junction

A GaN enhancement-mode reverse blocking MISHEMT with MIS field-effect drain for bidirectional switch

A High-Performance GaN E-mode Reverse Blocking MISHEMT with MIS Field Effect Drain for Bidirectional Switch

Reverse-Blocking Normally-OFF GaN Double-Channel MOS-HEMT with Low Reverse Leakage Current and Low ON-State Resistance

Schottky-Ohmic Drain Algan/Gan Normally off Hemt with Reverse Drain Blocking Capability

High-performance reverse blocking p-GaN HEMTs with recessed Schottky and p-GaN isolation blocks drain

Reverse Blocking P-Gan Gate AlGaN/GaN HEMTs with Hybrid P-Gan Ohmic Drain

On the coupled effect of a MIS-based anode and AlGaN-polarized super-junction to reduce the local electric field for AlGaN/GaN Schottky barrier diodes

Reverse-Conducting Normally-OFF Double-Channel AlGaN/GaN Power Transistor with Interdigital Built-In Schottky Barrier Diode

Low contact resistance and high breakdown voltage of AlGaN/GaN HEMT grown on silicon using both AlN/GaN superlattice and Al0.07Ga0.93N back barrier layer

Interface Charge Engineering in Down-Scaled AlGaN (<6 Nm)/gan Heterostructure for Fabrication of GaN-based Power HEMTs and MIS-HEMTs

Reverse Blocking P-Gan Gate HEMTs with Multicolumn P-Gan/schottky Alternate-Island Drain

Normally-Off p-GaN Gated AlGaN/GaN MIS-HEMTs with ALD-Grown Al2O3/AlN Composite Gate Insulator

Asymmetric GaN High Electron Mobility Transistors Design with InAlN Barrier at Source Side and AlGaN Barrier at Drain Side

A non-Ohmic normally-off GaN monolithic bidirectional switch with MIS field effect schottky tunnel junction

High-performance AlGaN/GaN MIS-HEMT Device Based on in Situ Plasma Nitriding and Low Power Chemical Vapor Deposition Si3N4 Gate Dielectrics

Reverse Blocking Enhancement‐Mode AlGaN/GaN HEMTs with Hybrid P‐gan Ohmic Drain on the Si Substrates