Effective Design of a Co-Ni-Al-W-Ta-Ti Alloy with High Γ′ Solvus Temperature and Microstructural Stability Using Combined CALPHAD and Experimental Approaches

Wendao Li,Longfei Li,Stoichko Antonov,Qiang Feng
DOI: https://doi.org/10.1016/j.matdes.2019.107912
IF: 9.417
2019-01-01
Materials & Design
Abstract:Alloy design of a Co-Ni-Al-W-Ta-Ti senary alloy was performed through a CALPHAD (CALculation of PHAse Diagrams) approach coupled with experimental investigation, with aim to attain high gamma' solvus temperature, microstructural stability, as well as low density. The results of the thermodynamic calculations indicated that increasing the Ni content would broaden the gamma + gamma' two-phase region, meanwhile simultaneously increasing the Ni content and the Al/W ratio would lead to high gamma' solvus temperature and microstructural stability. The experimental results indicated that a high Al/W ratio with a high Ni content of > 20 at.% was beneficial not only for obtaining a high gamma' solvus temperature, but also for realizing high microstructural stability and low density in these Co-Al-W-base superalloys. Increasing the Ni content enhanced the hardness of both the gamma and gamma' phases, while increasing the AIM ratio had an opposite effect. The optimized alloy, Co-30Ni-11Al-4W-1Ta-4Ti (at.%), demonstrated solvus temperature of above 1200 degrees C, low density of 8.76 g/cm(3), and excellent microstructural stability after aging at 1150 degrees C for 1000 h. This study will be helpful for the continuous efforts on the development of Co-Al-W-base superalloys for industrial application, as well as populating thermodynamic databases. (C) 2019 The Authors. Published by Elsevier Ltd.
What problem does this paper attempt to address?