Abstract:Acetylene (C2H2) is one of the most important and typical characteristic fault gas dissolved in power transformer oil, and on-line monitoring its concentration could reflect the operational state of transformer timely, which could prevent safety issues of power grid effectively. Considering the traditional zinc oxide (ZnO) gas sensor exhibiting some shortcomings, such as higher operating temperature, lower response, poor selectivity, and so on. The paper proposes the ZnO-based (pure ZnO, cobalt-doped ZnO) gas sensors to contrastively study. The characterization results of nanomaterials (XRD, FESEM, HRTEM) show that the as-grown products possess the good crystal structure and high purity. The gas-sensing experiment results on optimum working temperature (Co-ZnO: 160 °C, pure ZnO: 180 °C), response-recovery time (Co-ZnO: 30–33 s, pure ZnO: 35–51 s), sensitivity (Co-ZnO: 9.886, pure ZnO: 1.971; 200 ppm C2H2), the limit of detection (3 ppm, Co-ZnO), stability (20, 50, 100, 200, 400 ppm C2H2), and selectivity (H2, CH4, C2H2, C2H4; 50, 100, 200 ppm) are obtained. They correspond to the theoretically analysis which based on the DFT-D calculations. The result of gas-sensing properties indicates that the dopant of Co is beneficial to reduce the optimum working temperature and response-recovery time significantly. In addition, it enhances the sensitivity of gas sensor evidently and process a good stability as well as selectivity. The orbital hybridization occurred during C2H2 adsorption, which promotes the electron transfer and conductivity changes. The results lay a solid foundation for the preparation of new ZnO-based gas sensor that serve for the transformer condition monitoring and fault diagnosis.

Analysis of Oil-dissolved Gases Based on Mid-infrared Absorption Spectroscopy With Difference Frequency Generation

Development of an Online Detection Setup for Dissolved Gas in Transformer Insulating Oil

Wireless Monitoring And Analysing System Of Dissolved Gases In The Transformer Oil

Diagnosis of power transformer faults on fuzzy three-ratio method

Quantitative Analysis of FTIR Used in Transformer On-line Monitoring

Portable ppb-level acetylene photoacoustic sensor for transformer on-field measurement

A highly sensitive low-pressure TDLAS sensor for detecting dissolved CO and CO 2 in transformer insulating oil

Low-Power Chemiresistive Gas Sensors for Transformer Fault Diagnosis

Analysis of Abnormal Detection Data of Dissolved Gases in 500kV Transformer Oil

Interpreting dissolved gases in transformer oil: A new method based on the analysis of labelled fault data

A new technique for fault diagnosis in transformer insulating oil based on infrared spectroscopy measurements

FAULT DIAGNOSIS OF INSULATION IN POWER TRANSFORMER BASED ON DISSOLVED GAS ANALYSIS METHOD

Total quality management and physicians' clinical decisions.

Study on ZnO-based gas sensor for detection of acetylene dissolved in transformer oil

Interference characteristics of leaking SF6 on photoacoustic detection of dissolved C2H4 in transformer oil

A Highly Sensitive and Durable Sensor for In Situ Hydrogen Measurement in Transformer Oil

Pd/C-Based Sensor for Gas Sensing in Transformer Oil

Fault Diagnosis Method for Power Transformers Based on Patterns of Dissolved Gases in the Oil

Power Transformer Diagnosis Based on Dissolved Gases Analysis and Copula Function

Dissolved gas monitoring probe without liquid-gas separation under strong electromagnetic interference

Fiber Bragg Grating Hydrogen Sensor Applied for Partial Discharge Detection in Transformer Oil