D retention in e-beam powder-bed fused (3–D printed) tungsten exposed to high-flux deuterium plasma in Pisces-RF

M.J. Baldwin,H. Zhang,A. Založnik,M.I. Patino,M.J. Simmonds,D. Nishijima,P.R. Carriere,G.R. Tynan,T. Horn
DOI: https://doi.org/10.1016/j.nme.2024.101626
IF: 3.037
2024-03-03
Nuclear Materials and Energy
Abstract:Tungsten targets produced by the additive manufacturing (AM) method of electron-beam powder-bed fusion, or 3–D metal printing, are exposed to high flux D plasma in the Pisces-RF linear plasma device with the plasma-exposed surface normal to the AM build direction. D retention was measured by thermal desorption mass spectrometry following exposure to D plasma with an associated ∼50eV D + ion flux. D + fluence, and operational temperature, in the ranges 5×1024 – 5×1026 m −2 and 400–1000 K, are explored. D retention values for the AM W are compared to identically plasma exposed'conventional' sintered W and it is found that total D retention is similar. However, the D thermal release is notably different. Desorption from the AM W shows reduced D retention in traps typical of sintered W, and moderately increased trapping in defect types of higher trap release energy. The dependence of D retention on fluence is also different for the AM W, revealing an uptake slower than expected from Fickian diffusion, while that for sintered W is consistent and in agreement with previous poly-crystaline W results from Pisces-B . Hydrogen transport modelling of the fluence dependence suggests that interconnected pathways for D release back to the surface during plasma-exposure can account for the slower D uptake in the AM W.
nuclear science & technology
What problem does this paper attempt to address?