Abstract:Zinc alloys shows strong strain rate dependent and anisotropic mechanical behaviours, the mechanistic origin of which is however not fully understood. In this work, a combination of the experiments and crystal plasticity finite element simulations were used to gain an insight into the relation between deformation mechanisms, tensile deformation behaviour and texture evolution, especially for the incipient plastic deformation stage. To this end, specimens were cut from Zn-Cu-Ti alloy sheets at various orientations with respect to the rolling direction, and uniaxial tensile tests were conducted at different strain rates ranging from 10-3 to 5 x 10-2 s- 1. The microstructure evolution with the deformation was examined by the electron backscatter diffraction technique. Crystal plasticity model was calibrated considering the effect of strain rate on the flow stress, and finite element simulations were carried out based on a representative volume element of the polycrystal zinc alloy. It is found out that the flow stress increases significantly, as the loading direction approaches the transverse direction, which results in a lower relative activity of basal slip and higher relative activity of non-basal ones. This, in turn, reduces the rotation of the c-axis of the crystallites towards ND during tensile tests. On the other hand, a positive strain rate sensitivity is found in the zinc alloy. Meanwhile, increasing strain rate leads to an obvious decrease in the activity of the pyramidal pi-II slip systems, accompanied by more activated twinning systems. The lower activity of the pyramidal pi-II slip at a higher strain rate probably hinders the development of CDRX and grain fragmentation at large strain levels.

The Elimination of the Yield Point Phenomenon in a New Zirconium Alloy: Influence of Degree of Recrystallization on the Tensile Properties

The Progressive Intensification and Attenuation of Yield Point Phenomenon in a New Polycrystalline Zirconium Alloy: Anisotropic Response of Work Hardening-Softening Transition

The Gradual Disappearance and Re-Appearance of Yield Drop by Modulating the Pre-Strain History in a New Zirconium Alloy: Dislocation Decomposition and Recombination

The Gradual Disappearance of Yield Plateau in Zr–Sn–Nb–Fe–Mo Alloy by the Trace Addition of Cr and V

Strain Hardening Versus Softening: Anisotropic Response of Strain Hardening-Softening Transition in a Polycrystalline Zirconium Alloy at Room Temperature from Dislocation Viewpoint

A Study of the Sharp Yield Point of a Ti-22Al-25Nb Alloy

Dynamic recrystallization and precipitation behavior of a novel Sc, Zr alloyed Al-Zn-Mg-Cu alloy during hot deformation

Revealing the High Strength and High Thermal Stability of a Nano-Lamellar Cu-0.1 At. % Zr Alloy

Hot Deformation Behavior and Microstructure Evolution of a Novel High-Zn Containing Al-Zn-Mg-Cu-Zr Alloy

Variation of Microstructural Features on the Tensile Property and Corrosion Resistance of Zr-Sn-Nb-Fe-Cu Alloy

Temperature effects on tensile behaviors and relevant deformation mechanisms of a low-cost nickel-based single crystal superalloy containing 1.5% Re

Confluent Effects of Initial Dislocation Microstructures on Yield Behavior in Single-Crystal Tungsten at High Temperature

Atomistic modeling for the extremely low and high temperature-dependent yield strength in a Ni-based single crystal superalloy

Interfacial dislocation evolution and yield mechanism of nickel-based single crystal superalloy: A molecular dynamics research

The Origin of Discontinuous Yielding in Mg Alloys under Slip-Dominated Condition Studied by In-Situ Synchrotron Diffraction and Elastic-Viscoplastic Self-Consistent Modeling

Strain Rate and Anisotropic Effects on Incipient Plastic Deformation of Zn–Cu–Ti Alloy Sheets

Deformation behavior and Microstructural evolution of Zr‐Sn‐Nb‐Fe alloy over a wide temperature range based on the law of mixture

Aging and Recrystallization Behavior of Precipitation Strengthened Al-0.25Zr-0.03Y Alloy

Effect of Microstructure on Stretch Property for Zr-Sn-Nb New Zirconium Alloys

Strain-Rate-Dependent Deformation Behavior of Ti29Zr24Nb23Hf24 High Entropy Alloys at Elevated and Room Temperature

Investigation on deformation mechanisms of Zr-1Sn-0.3Nb-0.3Fe-0.1Cr alloy using in situ EBSD/SEM