Abstract:Dual-band amplified spontaneous emission (ASE) can be used as a spectral analysis technique to detect specific chemical or biological molecules. In this paper, the dual-band ASE properties of blend films containing a small organic molecule N,N'-(4,4′-(1E,1′E)-2, 2′-(1,4-phenylene) bis(ethene-2,1-diyl)) −bis(4,1-phenylene))-bis(2-ethyl-6-methyl-phenylaniline) (BUBD-1) and a conductive polymer Poly(9,9-dioctylfluorenyl-2,7-diyl) (PFO) were investigated and optimized. As the doping concentration of BUBD-1 in the PFO was increased from PFO: 1 wt% BUBD-1 to PFO: 5 wt% BUBD-1, the ASE emission wavelength shifted from single- to dual-band and then back. The dual-band ASE performance of the blend film was also improved by introducing a Poly(methyl methacrylate) (PMMA) buffer layer containing silver nanoparticles (AgNPs), which resulted in a significant decrease in the excitation energy threshold of both ASE peaks and a significant increase in the net gain. Due to the LSPR effect of AgNPs, the ASE thresholds for peaks at 460 nm (PFO) and 490 nm (BUBD-1) in the blend film decreased from 12.24 ± 0.49 μJ/pulse to 6.99 ± 0.28 μJ/pulse and from 12.75 ± 0.51 μJ/pulse to 7.03 ± 0.28 μJ/pulse, respectively. The experimental and theoretical simulation demonstrated that the incomplete energy transfer between PFO and BUBD-1 led to a dual-band ASE effect. In addition, the enhanced light absorption, emission, and scattering caused by LSPR in the AgNPs improved the threshold and gain for dual-band ASE. This provides a possibility of realizing dual-band organic semiconductor lasers.

Theoretical and Experimental Analysis of Bidirectionally Pumped 1.3 Μm Pr3+-doped ASE Source

Experimental Realization of A Pbse Quantum Dot Doped Fiber Amplifier with Ultra-Bandwidth Characteristic

Modeling of a Diode Four-Side Pumped Cesium Vapor Laser Amplifier with Flowing Medium

A Simulation of PbSe Quantum Dot-Doped Fiber Laser

2 $μ$m Watt-level Fiber Amplifiers, Lasers, and ASE Sources Pumped by Broadband ASE Pumps

Characteristic Analysis of Praseodymium Doped Superfluorescent Fluoride Fiber Source Operating at 1.3 Μm

High Pump Conversion Efficiency and Broad L-Band ASE Sourceby Using Sagnac Feedback Loop

Amplified and Directional Spontaneous Emission from Arbitrary Composite Bodies: A Self-Consistent Treatment of Purcell Effect below Threshold

933 W Yb-doped Fiber ASE Amplifier with 504 Nm Bandwidth

Narrow-linewidth, quasi-continuous-wave ASE source based on a multiple-pass Nd:YAG zigzag slab amplifier configuration

Characterization of Visible Range Gain in Praseodymium Doped Fiber Amplifier

Theoretical and Experimental Investigations on Erbium-Doped Fiber Amplifiers

Amplification and Spontaneous Emission of Er-doped Fiber Both in Theory and Experiment

Parameters Optimization of ASE Source for the Improvement of Optical Power Stability in Space Radiation Environment

Extremely Low Threshold Quasi‐CW Amplified Spontaneous Emission Achieving and Its Mechanism Study

Pump Laser Automatic Signal Control for Erbium-Doped Fiber Amplifier Gain, Noise Figure, and Output Spectral Power

Optimized dual-band amplified spontaneous emission properties of PFO and BUBD-1 blend films based on AgNPs doped buffer layers

Theoretical Analysis on Gain Characteristics of Ytterbium-Doped Fiber Amplifier

Reduced Optically Pumped Amplified Spontaneous Emission Threshold of BUBD-1 Thin Films by Thermally Activated Delayed Fluorescent Materials

High-power and high-brightness Er:Yb codoped fiber MOPA operating at 1535 nm

Theoretical Analysis of Erbium-doped Superfluorescent Fiber Source in Double-pass Backward Configuration