Abstract:S-band fiber lasers, one type of ytterbium doped fiber lasers(YDFLs) which emitting in the spectral region of 1010 nm similar to 1050 nm, have drawn more and more attention especially after the proposition of tandem pump fiber lasers. The S-band laser plays an important role as the pump in a tandem pumping scheme. However, high power S-band laser output is quite difficult because of severe re-absorption. Therefore, the optical properties of S-band fiber lasers are studied and methods to achieve high power S-band laser output are presented. An S-band laser emission model based on gain comparison is built for analyzing the mechanism of laser oscillation and amplification. The model is composed of rate equations and gain comparison of several wavelengths in ASE spectrum. The gain differential between laser wavelength and ASE peak wavelength is compared to the additional gain imposed by cavity mirrors in an oscillator or the seed in an amplifier. The comparison results help in concluding the feasibility of S-band laser emission. Based on the model, the influences of fiber properties (including core doping level, core -clad ratio, and fiber length), pump power and laser power on the operation of S-band fiber lasers or amplifiers are researched. The analysis shows that fibers with lower doping level, larger core-clad ratio and shorter length, seed with higher power, are more helpful in realizing high power S-band laser output. Also, the profile of oscillator is found more suitable in building high power S-band lasers than that of amplifier.

High Pump Conversion Efficiency and Broad L-Band ASE Sourceby Using Sagnac Feedback Loop

Theoretical and Experimental Analysis of Bidirectionally Pumped 1.3 Μm Pr3+-doped ASE Source

2 $μ$m Watt-level Fiber Amplifiers, Lasers, and ASE Sources Pumped by Broadband ASE Pumps

L-Band Edfa Efficiency Enhancement And Dynamic Range Extension By C-Band Laser Injection

933 W Yb-doped Fiber ASE Amplifier with 504 Nm Bandwidth

Experiment of Wavelength Conversion of Spectrum-Sliced ASE Broadband Source Using Highly Nonlinear Fibers

Wavelength and Power Dependence of Injected C-band Laser on Pump Conversion Efficiency of L-band EDFA

Narrow-linewidth, quasi-continuous-wave ASE source based on a multiple-pass Nd:YAG zigzag slab amplifier configuration

Amplification and Spontaneous Emission of Er-doped Fiber Both in Theory and Experiment

Low-spatial-coherence broadband fiber source for speckle free imaging

High-power all-fiber superfluorescent source with fused angle-polished side-pumping configuration.

Raman Dissipative Soliton Fiber Laser Pumped by an ASE Source.

Experiment of C-Band Wavelength Conversion in a Silicon Waveguide Pumped by Dispersed Femtosecond Laser Pulse

301 W Narrow-Linewidth In-Band Pumped Er:Yb Co-Doped Fiber Amplifier at 1585 Nm and Related Modeling for Dynamics Study and Optimization

Performance Enhancement of C + L Band EDFA by Recycling the Residual Pump Lasers

Optical Properties of High Power S-Band Fiber Oscillators and Amplifiers

Broadband ASE source-enabled self-homodyne DA-RoF fronthaul using cascaded SOAs and a multicore fiber

Broadband ASE source-enabled self-homodyne DA-RoF fronthaul using cascaded SOAs and multicore fiber

13.9-Mj All Fiber Wide Band Ytterbium-Doped Fiber Amplifier

Storage energy from high energy pulsed fiber amplifiers under the influence of amplified spontaneous emission

Inverse Design of Incoherent Raman Pump Sources for U-Band WDM Transmission Over 125 km G.652.D Fiber