Abstract:S-band fiber lasers, one type of ytterbium doped fiber lasers(YDFLs) which emitting in the spectral region of 1010 nm similar to 1050 nm, have drawn more and more attention especially after the proposition of tandem pump fiber lasers. The S-band laser plays an important role as the pump in a tandem pumping scheme. However, high power S-band laser output is quite difficult because of severe re-absorption. Therefore, the optical properties of S-band fiber lasers are studied and methods to achieve high power S-band laser output are presented. An S-band laser emission model based on gain comparison is built for analyzing the mechanism of laser oscillation and amplification. The model is composed of rate equations and gain comparison of several wavelengths in ASE spectrum. The gain differential between laser wavelength and ASE peak wavelength is compared to the additional gain imposed by cavity mirrors in an oscillator or the seed in an amplifier. The comparison results help in concluding the feasibility of S-band laser emission. Based on the model, the influences of fiber properties (including core doping level, core -clad ratio, and fiber length), pump power and laser power on the operation of S-band fiber lasers or amplifiers are researched. The analysis shows that fibers with lower doping level, larger core-clad ratio and shorter length, seed with higher power, are more helpful in realizing high power S-band laser output. Also, the profile of oscillator is found more suitable in building high power S-band lasers than that of amplifier.

Wavelength and Power Dependence of Injected C-band Laser on Pump Conversion Efficiency of L-band EDFA

L-Band Edfa Efficiency Enhancement And Dynamic Range Extension By C-Band Laser Injection

301 W Narrow-Linewidth In-Band Pumped Er:Yb Co-Doped Fiber Amplifier at 1585 Nm and Related Modeling for Dynamics Study and Optimization

Gain performance and gain modulation of 980nm-pumped erbium-doped fibre amplifiers

Optimally Gain-Flattened and Dispersion-Managed C + L-band Hybrid Amplifier Using a Single-Wavelength Pump Laser

Performance Enhancement of C + L Band EDFA by Recycling the Residual Pump Lasers

Experiment of C-Band Wavelength Conversion in a Silicon Waveguide Pumped by Dispersed Femtosecond Laser Pulse

Gain-Enhanced Double-Pass Long-Wavelength-Band Erbium-Doped Fiber Amplifier Using Backward Pumping

Pump Laser Automatic Signal Control for Erbium-Doped Fiber Amplifier Gain, Noise Figure, and Output Spectral Power

Gain Performances of 980 Nm-Pumped Erbium-Doped Fiber Amplifiers

Theoretical and Experimental Investigations on Erbium-Doped Fiber Amplifiers

Experimental study of two-stage erbium doped fiber amplifiers pumped by 980 nm and 1480nm LD

C+L-Band Erbium-Doped Fiber Broadband Light Source Using One-Stage Configuration

Numerical Simulation Of 980 Nm-Ld-Pumped Yb3+-Er3+-Tm3+-Codoped Fiber Amplifier For 1500nm And 1600nm Bands

Pump quantum efficiency optimization of 3.5 μm Er-doped ZBLAN fiber laser for high-power operation

Numerical analysis of amplification characteristic of erbium-doped waveguide amplifiers by FD-BPM

219.6 W large-mode-area Er:Yb codoped fiber amplifier operating at 1600 nm pumped by 1018 nm fiber lasers

Influence of Multimode-Pump Propagation on the Gain Characteristics of Erbium–ytterbium Doped Waveguide Amplifier

Numerical Simulation of 980 nm-LD-Pumped Yb 3 +-Er 3 +-Tm 3 +-Codoped Fiber Amplifier for 1500 nm and 1600 nmBands

Optical Properties of High Power S-Band Fiber Oscillators and Amplifiers

An Erbium-Doped Fiber Amplifier With Tunable Gain-Clamping in the Extended L-Band