Abstract:Recent progress on high efficiency Tm-doped silica fibers pumped at 790nm has enabled the demonstration of a 2 mu m CW fiber laser operating at the 1kW power level and with single mode beam quality [1]. In addition to this state-of-the-art high power research, Tm-doped fibers are now starting to find applications in lasers with nsec [2] and psec [3] pulsed operation, as well as lower power CW lasers (50-100W) in the 1940nm wavelength region for medical use [4].As with Yb-doped fibers, the question of photodarkening needs to be addressed to ensure the long term fiber reliability is appropriate for the application. In a recent paper [5], we proposed that the up-conversion process in highly doped Tm-fibers was significantly quenched when compared with lower concentration fibers, under 790nm pumping. This trend was also observed in the photodarkening rate as measured in a CW 2 mu m fiber laser cavity operating around 20W output power. In this controlled experiment, the rate of photodarkening dropped from 15% per 1000 hours in low concentration fiber to less than 1% in a fiber doped with 4.6% Tm.In this paper we review the 20W results of our earlier work and then confirm the long term reliability of 1940nm CW fiber lasers operating at higher (40W) output power, presenting results for a laser operating for 1200 hours without significant loss of output power (around 12% total power variation). Over any given 24-hour period during this experiment, the laser operates open loop with around 8% total power variation, in an air cooled configuration. We believe these results confirm the appropriate level of long term reliability of Tm-doped fibers for CW fiber lasers at the similar to 50W power level, suitable for medical laser applications.

Elimination of the Photodarkening Effect in an Yb-Doped Fiber Laser with Deuterium

Mitigation of Photodarkening Effect in Yb-doped Fiber Through Na+ Ions Doping.

Photodarkening in Ytterbium-doped Fiber with High Doping Concentration

532 nm pump induced photo-darkening inhibition and photo-bleaching in high power Yb-doped fiber amplifiers

Influence of Pre-Radiation and Photo-Bleaching on the Yb-Doped Fiber Laser Radiated with Gamma-ray

Photodarkening Effect Suppression in Yb-doped Fiber Through the Nanoporous Glass Phase-Separation Fabrication Method

Time Response Characteristics of Photodarkening-Induced Loss in Yb-Doped Fiber Amplifier

Impact of gamma-ray radiation-induced photodarkening on mode instability degradation of an ytterbium-doped fiber amplifier

1010 nm Directly LD-Pumped 6kW Monolithic Fiber Laser Employing Long-Tapered Yb3+-Doped Fiber

High-temperature-insensitivity high-power Yb-doped fiber laser directly in-band pumping by 1018 nm laser diodes

Reliability and Photodarkening in 790Nm-Pumped 2μm Fiber Lasers

A LD pumped gain switched Yb3+ doped double-cladding fiber laser

Optical and laser damage properties of 98% deuterium DKDP crystal in different crystal orientations

Analysis of Raman and thermal effects in kilowatt fiber lasers

Deep UV-induced near-infrared photodarkening of Er/Yb-doped and undoped phosphate fibers

Photodarkening-Induced Phase Distortions and Their Effects in Single-Channel and Coherently Combined Yb-Doped Fiber Chirped Pulse Amplification Systems

301 W Narrow-Linewidth In-Band Pumped Er:Yb Co-Doped Fiber Amplifier at 1585 Nm and Related Modeling for Dynamics Study and Optimization

Gamma Radiation Induced Darkening Effect on Ytterbium Doped Fiber Oscillators

Integration of an anti-resonant hollow-core fiber with a multimode Yb-doped fiber for high power near-diffraction-limited laser operation

Ytterbium-doped fibers for high-power fiber lasers

Yb-doped large-mode-area laser fiber fabricated by halide-gas-phase-doping technique