Abstract:High-energy irradiation significantly increases the optical losses and noise coefficients of laser materials, leading to a substantial decrease in the slope efficiency or gain performance of laser output. To address this issue, we propose a strategy to enhance the radiation resistance of glasses/fibers by introducing phase interfaces. Based on the sol–gel method, through phase-separation techniques and high-temperature annealing treatments, silica-rich and phosphorus-rich phases were formed in erbium-ytterbium co-doped high-phosphorus silica glass, and nanoscale phase interfaces with specific densities, stability levels, and homogeneous distributions of doped elements were constructed between the phases. Using high-resolution transmission electron microscopy, nuclear magnetic resonance, and spectroscopic analyses, we tracked the evolution of the internal microstructure of the glasses at the atomic level. The findings confirmed that annealing effectively controlled the density of the phase interfaces formed. Under 1 kGy X-ray irradiation, glasses with effective phase interfaces exhibited significant reduction in radiation-induced attenuation (RIA) and improvement in photoluminescence intensity compared to pristine glasses. This indicated that effective phase interfaces could act as complex centers for irradiation-induced point defects, absorbing radiant energy and trapping these defects, thus mitigating high-energy radiation-induced damages. Furthermore, online irradiation tests on the Er 3+ /Yb 3+ co-doped silica fibers supported this result. Compared to pristine fiber, fibers annealed for 3 h and annealed for 20 h with different phase interfacial densities showed 45% and 73% lower RIA at 1080 nm, respectively.

Photodarkening Effect Suppression in Yb-doped Fiber Through the Nanoporous Glass Phase-Separation Fabrication Method

Mitigation of Photodarkening Effect in Yb-doped Fiber Through Na+ Ions Doping.

Broadband Noise-Like Pulse Generation at 1 Μm Via Dispersion and Nonlinearity Management.

Glass Nanofibers for Micro- and Nano-Scale Photonic Devices

Simultaneously Achieving a Large Negative Dispersion and a High Birefringence Over Er and Tm Dual Gain Bands in a Square Lattice Photonic Crystal Fiber

532 nm pump induced photo-darkening inhibition and photo-bleaching in high power Yb-doped fiber amplifiers

Elimination of the Photodarkening Effect in an Yb-Doped Fiber Laser with Deuterium

Influence of Pre-Radiation and Photo-Bleaching on the Yb-Doped Fiber Laser Radiated with Gamma-ray

Deep UV-induced near-infrared photodarkening of Er/Yb-doped and undoped phosphate fibers

Impact of gamma-ray radiation-induced photodarkening on mode instability degradation of an ytterbium-doped fiber amplifier

Enhanced radiation resistance of Er3+/Yb3+ co-doped high-phosphorus silica glasses and fibers via phase-interface engineering

Double-clad large-mode-area polarization-maintaining ytterbium doped photonic crystal fiber

Efficient laser operation with low loss Nd3+-doped phosphate glass fiber under direct pumping

Yb-doped large-mode-area laser fiber fabricated by halide-gas-phase-doping technique

A novel route to fabricate Yb:YAG ceramic fiber and its optical performance

Precisely controllable fabrication of Er3+-doped glass ceramic fibers: novel mid-infrared fiber laser materials

Fabrication and Characterization of Er~(3+):Yb~(3+) Co-doped Phosphosilicate Fibers

Yb-Doped Aluminophosphosilicate Laser Fiber

Pr3+-doped YPO4 nanocrystal embedded into an optical fiber

Ytterbium-Phosphate Glass for Microstructured Fiber Laser

193 nm excimer laser-induced color centers in Yb3+/Al3+/P5+-doped silica glasses