Abstract:Partial discharge is an important cause of insulation degradation for dry type transformer. The longstanding discharge will accelerate the insulation aging of epoxy resin insulation, what would even lead to defects such as short circuit or insulation breakdown. The generation of partial discharge can produce ultrasonic signal. Ultrasonic detection method has strong resistance to electromagnetic interference, what makes it suitable for partial discharge defect detection of dry type transformer. In this paper, the propagation laws of ultrasonic signal in dry type transformer are studied by simulation, and the propagation laws of ultrasonic signal are compared under two different discharge defects: bubble discharge in epoxy resin insulation and air gap discharge at the junction of insulation and copper winding. The reasonable installation positions of ultrasonic sensors on dry type transformer are explored according to the results. The results show that the ultrasonic signal will decay rapidly during the transmission in dry type transformer. Under the same discharge fault, ultrasonic signal measured in the non-fault phase is much smaller than that in the fault phase. The refraction and reflection of ultrasonic signal between different materials can be ignored because the sizes of windings and epoxy resin structures are much smaller than ultrasonic wavelength, so the ultrasonic pressure at different measurement points mainly depend on the relative positions of the discharge point and measurement points. A sensor on the upper surface of the core in one phase can measure relatively stronger ultrasonic signal from threephase partial discharge, and a sufficient gain should be set for the sensor on the upper surface of the core to realize the monitor of partial discharge from three phases while using less sensors.

Study on a Partial Discharge Detection Method for Transformers Adopting the End Shield As UHF Sensor

A Novel Partial Discharge Detection Method for Power Transformers on Site Adopting Its Component As Ultra-High Frequency Sensor

UHF Signal External Detection of Partial Discharge in Transformers

Investigation of the UHF Partial Discharge Detection Characteristics of a Novel Bushing Tap Sensor for Transformers

Application of Ultra-high-frequency Partial Discharge Detection in Power Transformers

Experimental Study for Outside Propagation Characteristic of the UHF Signal Emitted by Partial Discharge in Transformers

A Feasibility Study on Bushing Tap UHF Sensing Method for Partial Discharge in Transformer

Propagation Characteristic Study Of Partial Discharge Uhf Signal Outside Transformer

Study Of On-Line Monitoring Method Of Partial Discharge For Power Transformers Based On Rfct And Microstrip Antenna

Application of Ultra High Frequency (UHF) Partial Discharge (PD) Test Technology to On-line Monitoring of Transformers

A Partial Discharge Detection Method for SF 6 Insulated Inverted Current Transformers Adopting Inner Shield Case As UHF Sensor

An Advanced Method for Detection of Partial Discharge in Oil-Paper Insulated Transformer Bushings and Current Transformers

Field test on a transformer for partial discharge location by uwb-rf method

Experimental Investigation of Partial Discharge Detection in Medium-Voltage Switchgear Based on Ultra-High-Frequency Sensor

Study on the Ultra-High-frequency Sensors for PD Detection in Power Transformer

Research on Ultrasonic Detection Method for Partial Discharge of Dry Type Transformer

Comparison of Pd Detection Methods for Power Transformers - Their Sensitivity and Characteristics in Time and Frequency Domain

Condition Monitoring Technology of Transformer with Multiple Sensing Methods United

Partial discharge localisation in transformers using UHF technique: non-iterative method

Simulation Study on Ultrasonic Signal Propagation Characteristics of Partial Discharge in Transformers

Detection Technology of Partial Discharge in Transformer Based on Optical Signal