Abstract:Objective In order to find early latent faults and prevent catastrophic failures, diagnosis of insulation condition by measuring technique of partial discharge(PD) in gas insulated switchgear (GIS) is applied in this paper, which is one of the most basic ways for diagnosis of insulation condition. Methods Ultra high frequency(UHF) PD detection method by using internal sensors has been proved efficient, because it may avoid the disturbance of corona, but the sensor installation of this method will be limited by the structure and operation condition of GIS. There are some of electromagnetic (E-M) waves leak from the place of insulation spacer, therefore, the external sensors UHF measuring PD technique is applied, which isn't limited by the operation condition of GIS. Results This paper analyzes propagated electromagnetic (E-M) waves of partial discharge pulse excited by using the finite-difference time-domain (FDTD) method. The signal collected at the outer point is more complex than that of the inner point, and the signals' amplitude of outer is about half of the inner, because it propagates through spacer and insulation slot. Set up UHF PD measuring system. The typical PD in 252kV GIS bus bar was measured using PD detection UHF technique with external sensors. Finally, compare the results of UHF measuring technique using external sensors with the results of FDTD method simulation and the traditional IEC60270 method detection. Conclusion The results of experiment shows that the UHF technique can realize the diagnosis of insulation condition, the results of FDTD method simulation and the result UHF method detection can demonstrate each other, which gives references to further researches and application for UHF PD measuring technique.

A Partial Discharge Detection Method for SF 6 Insulated Inverted Current Transformers Adopting Inner Shield Case As UHF Sensor

A Novel Partial Discharge Detection Method for Power Transformers on Site Adopting Its Component As Ultra-High Frequency Sensor

Study on a Partial Discharge Detection Method for Transformers Adopting the End Shield As UHF Sensor

Investigation of the UHF Partial Discharge Detection Characteristics of a Novel Bushing Tap Sensor for Transformers

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Experimental Investigation on UHF Partial Discharge Sensor in GIS

UHF Signal External Detection of Partial Discharge in Transformers

THE STUDY ON MEASURING TECHNIQUE OF PARTIAL DISCHARGE IN GAS INSULATED SWITCHGEAR USING ULTRA HIGH FREQUENCY METHOD WITH EXTERNAL SENSORS

Design, Optimization and Experiment Study of Internal UHF Sensor for Partial Discharge Detection in GIS

Partial Discharge Detection by Extracting UHF Signal from Inner Grading Electrode of Insulating Spacer in GIS

Experimental Study for Outside Propagation Characteristic of the UHF Signal Emitted by Partial Discharge in Transformers

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Application of Ultra-high-frequency Partial Discharge Detection in Power Transformers

A Novel GIS Partial Discharge Detection Sensor with Integrated Optical and UHF Methods

The Optimal Circumferential Angle Position Of Uhf Sensor For Partial Discharge Detection In Gis

Application of HFCT and UHF Sensors in On-Line Partial Discharge Measurements for Insulation Diagnosis of High Voltage Equipment

Diagnosis of Partial Discharge in GIS Based on UHF Sensing Technique

Primary Differential Pulse Method for Partial-Discharge Detection of Oil-Immersed Inverted Current Transformers

Experimental Investigation of Partial Discharge Detection in Medium-Voltage Switchgear Based on Ultra-High-Frequency Sensor

A Feasibility Study on Bushing Tap UHF Sensing Method for Partial Discharge in Transformer