Abstract:The power transformer is one of the most crucial pieces of high-voltage equipment in the power system, and its stable operation is crucial to the reliability of power transmission. Partial discharge (PD) is a key factor leading to the degradation and failure of the insulation performance of power transformers. Therefore, online monitoring of partial discharge can not only obtain real-time information on the operating status of the equipment but also effectively predict the remaining service life of the transformer. Meanwhile, accurate localization of partial discharge sources can assist maintenance personnel in developing more precise and efficient maintenance plans, ensuring the stable operation of the power system. Dual partial discharge sources in transformer oil represent a more complex fault type, and piezoelectric transducers installed outside the transformer oil tank often fail to accurately capture such discharge waveforms. Additionally, the sensitivity of the built-in F-P sensors can decrease when installed deep within the oil tank due to the influence of oil pressure on its sensing diaphragm, resulting in an inability to accurately detect dual partial discharge sources in transformer oil. To address the impact of oil pressure on sensor sensitivity and achieve the detection of dual partial discharge sources under high-voltage conditions in transformers, this paper proposes an optical fiber ultrasonic sensor with a pressure-balancing structure. This sensor can adapt to changes in oil pressure environments inside transformers, has strong electromagnetic interference resistance, and can be installed deep within the oil tank to detect dual partial discharge sources. In this study, a dual PD detection system based on this sensor array is developed, employing a cross-positioning algorithm to achieve detection and localization of dual partial discharge sources in transformer oil. When applied to a 35 kV single-phase transformer for dual partial discharge source detection in different regions, the sensor array exhibits good sensitivity under high oil pressure conditions, enabling the detection and localization of dual partial discharge sources in oil and winding interturn without obstruction. For fault regions with obstructions, such as within the oil channel of the transformer winding, the sensor exhibits the capability to detect the discharge waveform stemming from dual partial discharge sources. Overall, the sensor demonstrates good sensitivity and directional clarity, providing effective detection of dual PD sources generated inside transformers.

Primary Differential Pulse Method for Partial-Discharge Detection of Oil-Immersed Inverted Current Transformers

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Comparison of Pd Detection Methods for Power Transformers - Their Sensitivity and Characteristics in Time and Frequency Domain

An Advanced Method for Detection of Partial Discharge in Oil-Paper Insulated Transformer Bushings and Current Transformers

Measurement and Analysis for Pulse Current Shapes of Partial Discharge in Oil under DC Voltage

Study on pulse current of typical PD models in power transformer

A Novel Method for Extracting Features of Partial Discharge Pulse Current Signal

Study Of On-Line Monitoring Method Of Partial Discharge For Power Transformers Based On Rfct And Microstrip Antenna

Detection Technology of Partial Discharge in Transformer Based on Optical Signal

Comparative Research on Current Pulse Method and UHF Measurements of Partial Discharge in Mineral Oil

Design of Double Needles Defect Model in Oil Immersed Inverted Current Transformer and Its Partial Discharge Characteristic

Interference Suppression in Partial Discharge Experiments of Current Transformer

A Novel Partial Discharge Detection Method for Power Transformers on Site Adopting Its Component As Ultra-High Frequency Sensor

Partial Discharge Localization Method in Transformer Based on Dissolved Gas Diffusion Inversion

Detection and Identification Technologies of Wide Band Partial Discharge

On-site Application of Partial Discharge Detection of Transformer Using Very Wide Bandwidth Pulse Current Method

Application of Antijamming Measure of Differential Balanced Method in PD On-Line Mornitoring of Transformer

Analysis of Multi-Physical Signal Characteristics of Inter-Turn Oil-Paper Insulation Partial Discharge

Locating Partial Discharge in Power Transformer by Electrical Method

Localization for Dual Partial Discharge Sources in Transformer Oil Using Pressure-Balanced Fiber-Optic Ultrasonic Sensor Array

Research on a New PD Detection Sensor in Transformer Oil Tank Seam