Abstract:Partial discharge measurement plays an important role in the assessment of insulation status and fault diagnosis of power equipment. Presently, the most commonly used industrial applications of PD detections are based on the broadband measurement systems that count amplified PD pulses. The limitations of these traditional measurements are that the system requires a relatively high sampling rate and calculation capability, and is very sensitive to the ambient noise. To eliminate noise interference and save the cost of PD detection system, a technique measurement of excess currents, which measures the dielectric response currents through test object before and after PD activities to capture the activities of PD, has been reported in some recent studies. This work aims to explore the parameters that characterize the PD activities via excess current technology and to seek new ideas for PD detection. In this work, a measurement setup for measurement of PD excess currents averaged from 300 periods is applied and three typical insulation defect models were tested under 50Hz voltages. Excess currents for each case are measured. Then the corresponding dielectric loss factors and circuit impedances are obtained by comparing them to the synchronous voltages. The results show that the loss factors increase after PD while the circuit impedances decrease. Meanwhile, the loss factors continue to increase and the circuit impedances continue to decrease as the voltages turn up where the rate of the change shows more rapid in the needle-plate model. Moreover, the loss factors and circuit impedances in the dielectric barrier model and air void model are respectively higher and lower than the values before PD when the voltages drop below the PD extinction voltages, which does not appear in the needle-plate model. These characteristics provide a new idea for PD detection by monitoring the loss factors or circuit impedances via excess current detection.

Interference Suppression in Partial Discharge Experiments of Current Transformer

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Anti-interference in Partial Discharge Test for Current Transformer Supplied with Variable-frequency Power

STUDY OF SUPPRESSING INTERFERENCE IN PARTIAL DISCHARGE (PD) ON-LINE MONITORING FOR TRANSFORMERS

Interference analysis and suppression technology of converter transformer partial discharge test based on field measurement

Suppression of Pulse Interference in Partial Discharge Measurement Based on Phase Correlation and Waveform Characteristics

Primary Differential Pulse Method for Partial-Discharge Detection of Oil-Immersed Inverted Current Transformers

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

Detection and Identification Technologies of Wide Band Partial Discharge

Comparison of Pd Detection Methods for Power Transformers - Their Sensitivity and Characteristics in Time and Frequency Domain

An Advanced Method for Detection of Partial Discharge in Oil-Paper Insulated Transformer Bushings and Current Transformers

The Frequency Range Selection for Measurement of Partial Discharge in Transformer Oil with UHF Method and Interference Suppression

Detection Technology of Partial Discharge in Transformer Based on Optical Signal

Study Of On-Line Monitoring Method Of Partial Discharge For Power Transformers Based On Rfct And Microstrip Antenna

Investigation of the UHF Partial Discharge Detection Characteristics of a Novel Bushing Tap Sensor for Transformers

Research on Time-Domain Transfer Impedance Measurement Technology for High Frequency Current Transformers in Partial Discharge Detection of Cables

Review of Partial Discharge Live Detection and Location Technology for Power Transformer

Study on pulse current of typical PD models in power transformer

A Novel Method for Extracting Features of Partial Discharge Pulse Current Signal

Separation of Multiple Partial Discharge Sources in Power Transformer