Abstract:The zero-sequence loop inherently exists in the structure of the three-phase open-end winding permanent-magnet synchronous machine (OW-PMSM) system with common dc bus, which provides the circulating path for zero-sequence current (ZSC) and consequently causes the torque ripple and extra system loss. Besides, the common-mode voltage (CMV), which can cause many negative effects, such as the bearing current and the failure of motor bearing, is another concern in the driving system. However, the simultaneous suppression of ZSC and the CMV control of the devices is investigated mainly in the application of the induction machine system and the multiphase OW-PMSM system, whereas it is ignored in the application of the three-phase OW-PMSM system, in which the suppression of ZSC is more complex considering the effect of flux linkage harmonic components. On this basis, this article proposes a strategy that can not only suppress the ZSC, but also eliminate the ripple of CMV in the three-phase OW-PMSM system. In the proposed method, the suppression of ZSC is achieved by synchronously adjusting the duration time of each phase within every control cycle based on the reference voltage of zero-sequence control loop, which can simplify the conventional rearrangement-based scheme. Furthermore, the duration time of each phase is distributed into each switch device of the two inverters, with the principle of eliminating the ripple of CMV. Consequently, both the suppression of ZSC and the CMV control can be achieved easily. Furthermore, the influence of dead time on the CMV control is analyzed, indicating that the CMV control is irrelevant with the dead time. Moreover, the effective modulation range of the proposed technique is analyzed. Finally, the experimental validation is conducted on a three-phase OW-PMSM system with common dc bus.

A Unified Modulation Strategy Based on Current Prediction Control for Open-Winding PMSM with Four Bridge Arms

A Fault Tolerant Control Strategy for Dual Three-Phase PMSM under Single-Phase Open Circuit Fault Considering Inductance Asymmetry

A Sinusoidal Current Control Method for SPMSM Considering Uneven Demagnetization Fault

Space Vector Modulation Based On Lookup Table For A Dual-Inverter-Fed Open-End Winding Pmsm Drive

Control Strategy for Open Winding PMSM System Supplied by the Z-source and Voltage Source Integrated Converters

A Sensorless Drive Strategy for Open-End Winding PMSM with Common DC Voltage Based on Lower Switching Frequency

Synthetic Vectors-Based Predictive Control of Dual Three-Phase PMSMs for Current Harmonics Mitigation Considering Average Deception Effect

Bilateral Four-Segment-Mode Model Predictive Control for Open-Winding PMSM Drives

Simplified Modulation Scheme for Open-End Winding PMSM System with Common DC Bus under Open-Phase Fault Based on Circulating Current Suppression

Torque Ripple Suppression Method with Reduced Switching Frequency for Open-Winding PMSM Drives with Common DC Bus.

Model Predictive Control with Duty Ratio Modulation for Open-Winding PMSM Driveswith Common DC Bus

Zero Sequence Current Suppression Strategy for Open Winding PMSG Fed by Semi-controlled Converter

Two New-type Control Strategies for Six-Phase Open Winding PMSM

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

Robust Model Predictive Current Control for a Nine-Phase Open-End Winding PMSM With High Computational Efficiency

Zero-Sequence Current Suppression Strategy with Common-Mode Voltage Control for Open-End Winding PMSM Drives with Common DC Bus

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

Open Winding PMSM System for Electric Vehicles Collaboratively Supplied by the Z-Source and Voltage Source Converters

Virtual Voltage Vector Based Model Predictive Control for a Nine-Phase Open-End Winding PMSM With a Common DC Bus

An Improved Modulation Technique with Minimum Switching Actions within One PWM cycle for Open-End Winding PMSM System with Isolated DC BUS

Model Predictive Control Of Semi-Controllable Open Winding Pmsg Based On Three Level Npc Converter