Abstract:The equivalent linearization method is an efficient and approximate method in analyzing the vibration characteristics of a flexible beam with large deformation, but the small amplitude hypothesis is the precondition of this method. The traditional fully nonlinear methods are usually incapable of characterizing explicitly the influence of geometric nonlinear properties on structure parameters; neither can it satisfy the requirements of the reduced-order models. The present paper considers the vibrating behaviors of a flexible cantilever beam with large deformation, and developes an equivalent linearization method to calculate the vibrating response of this beam. The proposed method can equivalently consider the effects of large static deformation on the vibration properties of a beam as the variations of the cross section moment of inertia and mass density distribution. In order to further determine the limitation of the small amplitude hypothesis, a flexible cantilever beam with large deformation is designed and manufactured, and three frequency response function (FRF) curves under three different vibrating amplitude levels are measured by the fixed frequency steady state exciting method. The comparisons between simulation and experimental results show that, when the ratio of tip dynamic displacement amplitude to static deformation amplitude is less than 10%, the changes of measured FRF curves are very small. So the system can be regarded as a linear system, and the relative error of the proposed equivalent linearization method is equal to or less than 6%, and the approximate method is effective. But when the ratio of tip dynamic displacement amplitude to static deformation amplitude is more than 20%, the value of the measured FRF at a resonant frequency point is significantly decreased, and the relative error of the equivalent linearization method is more than 50%, and this method is no longer suitable. And the nonlinear vibration behavior of the experimental flexible cantilever beam is dominated by the structural damping nonlinear property.

Analysis and Modeling of Deflection and Pull in Voltage of Cantilever Beam

Analytical model of electrostatic fixed-fixed microbeam for pull-in voltage

Electrostatic-Nonlinear Beam Coupling Problem Solved by Galerkin Spectral Method

Static deflections analysis of micro-cantilevers beam under transverse loading

Modeling analytically the pull-in of double-cantilever structure

Deflection Control of an Active Beam String Structure Using a Hybrid Genetic Algorithm and Back-Propagation Neural Network

Active vibration control of a cantilever beam based on neural network online identification

DEFLECTION MODEL CONSIDERING PRESSURE FOLLOWING EFFECT AND TEST SYSTEM DESIGN OF AN INFLATABLE CANTILEVER BEAM

An Analytical Model for Pull-in Voltage of Clamped–clamped Multilayer Beams

Optimization Algorithm-Based Approach for Modelling Large Deflection of Cantilever Beam Subjected to Tip Load

Modeling the Pull‐in Behavior of Electrostatically Actuated Micro Beams by an Approximate Finite Element Method

Performance analysis of Micro-cantilever beams and sensor data fitting

Closed Form Solutions for Nonlinear Static Response of Curled Cantilever Micro-/Nanobeams Including Both the Fringing Field and Van Der Waals Force Effect

Pull-in voltage analysis for an electrostatically actuated extensional microbeam with large deflection

Modeling and Analysis for Moving Plate with Two-Dimensional Effect

Optimization algorithm-based approach for modeling large deflection of cantilever beam subject to tip load

Brief and Accurate Analytical Approximations to Nonlinear Static Response of Curled Cantilever Micro Beams

Vibration Characteristics of a Flexible Cantilever Beam and Limitations of Equivalent Linearized Method

Modeling and analysis for moving plate with two-dimension effect

Fitting Correction for an Analytical Model of Pull-in Voltage of Fixed-Fixed Beams

Sensor-Based Reconstruction of Slender Flexible Beams Undergoing Large-scale Deflection.