Abstract:Using high-strength (HS) materials in steel–concrete composite beams is an efficient approach to reduce the self-weight and to improve the sustainability benefits of such members. Due to a lack of precise knowledge of the ductility of composite beams beyond their first yield as a result of the non-linear response of their constituent materials, a comprehensive investigation is reported herein to quantify the available rotation capacity of composite beams using HS materials when subjected to sagging bending. An advanced three-dimensional finite element model is utilised to calculate the end rotation of single-point-loaded simply-supported composite beams. The model has demonstrated to be adequate and reliable in terms of predicting the flexural strength and load–deflection response by comparisons with numerous experimental results reported elsewhere. As many as 1380 beams with various strengths of steel and concrete as well as a wide range of the degree of shear connection and geometries are modelled, and both solid slabs and composite slabs using profiled steel decking are incorporated. Analyses of this body of data indicate that the depth of the neutral axis is the most essential parameter for determining the available sagging rotation capacity, of which an increased value leads to a lower rotation capacity. The yield strength of the steel also has noticeable effects with higher values resulting in poorer rotation performance. The available rotation capacity is also sensitive to the span-to-depth ratio of the beams. In addition, the effects of varying cross-sectional geometries, different patterns of shear connector distributions as well as of geometric imperfections and residual stresses are clarified, which are shown to be slight and can therefore be ignored. Finally, a non-linear empirical equation is developed to predict the available rotation capacity of composite beams using HS materials, which covers the range of numerical data with satisfactory consistency. The outcomes provide an important basis for evaluating the ductility of composite beams by comparing with the required rotation capacity.

Rotational Capacity of H-shaped Steel Beams under Cyclic Pure Bending

Experimental Study of Confined Hot-Rolled H-shape Steel Columns under Cyclic Loading

Load-Carrying Capacity and Practical Calculation Method for Hollow Cylinder Joints Connected with H-Shaped Beams

Experimental study and capacity analysis of double-tapered rectangular steel tubes

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

Bending behavior test of hybrid high performance steel beam

Experimental and Numerical Study on Cyclic Behaviour of Steel Beam-to-column Joints

Extremely Low-Cycle Fatigue Tests of Thick-Walled Steel Bridge Piers

Available rotation capacity of composite beams with high-strength materials under sagging moment

Experimental Research on Behavior of 460 MPa High Strength Steel I-section Columns under Cyclic Loading

Concrete-filled Thin-Walled Steel SHS and RHS Beam-Columns Subjected to Cyclic Loading

Experimental Study of Structural Steel Constitutive Relationship under Cyclic Loading

SHEAR BEHAVIOR ASSESSMENT OF REINFORCED CONCRETE BEAMS UNDER CYCLIC LOADING

Cyclic behavior of steel tube confined concrete beam-columns

Experimental and Constitutive Model Study of Structural Steel under Cyclic Loading

Cyclic Behavior of Very Short Steel Shear Links

Constitutive model for cyclic behavior of mild steel under various strain amplitudes

HSS Steel Corner Column to H-beam Joints under Cyclic Bidirectional Loadings: Experiment, Numerical Modeling, and Calculation

Mechanical performance of low-yield-point steel LYP225 under cyclic loading

Experimental and Modeling Study of High-Strength Structural Steel under Cyclic Loading