Abstract:With the development of large span and heavy load modern engineering, concrete-filled steel tubular truss and laced column structures appear constantly. The joints of these structures are mostly circular Concrete-Filled Steel Tubular (CFST) joints. In order to solve the problem of lacking of the research on the mechanical properties of CFST joints, three CFST T-joints and one Circular Hollow Section (CHS) T-joint which was used for comparing were tested under reversed cyclic axial loading, and three CFST T-joints and one CHS T-joint were tested under reversed cyclic in-plane bending loading. The failure modes and the ultimate load carrying capacities of CFST T-joints were concluded and the load-displacement hysteretic curves were also studied. The test results showed that the failure modes of CFST joints and CHS joints with the same geometry were completely different, the ultimate load carrying capacities of CFST joints were much higher than that of CHS joints, which shows that adopting a concrete-filled chord member is the most effective way to improve the strength of the unstiffened tubular joints when subjected to axial loading and in-plane bending, the energy dissipation mechanisms of CFST joints and CHS joints were completely different, but both CFST joints and CHS joints had excellent seismic performances. The energy analysis of CFST joints under differing loading conditions indicated that there was a significant distinction in terms of the energy dissipation mechanism. The axially loaded specimens dissipated energy mainly by plastic deformation of the brace, while the in-plane bending loaded specimens dissipated energy mainly by punching shear of the chord wall at the intersection area. This research can not only provide scientific basis for the design of CFST joints, but also effectively promote the application of CFST truss and laced column, and can promote the improvement and development of the design theory of concrete-filled steel structures.

Experimental and Numerical Study on Cyclic Behaviour of Steel Beam-to-column Joints

Experimental Study on Reduced I-beam to CFRST Column Joints under Cyclic Loading

EXPERIMENTAL STUDY ON THE SEISMIC BEHAVIOR OF CFST RECTANGULAR COLUMN TO H-SECTION STEEL BEAM CONNECTIONS WITH EXTERNAL STIFFENERS

Experimental Research on Seismic Behavior of Reinforced Concrete Column-to-Steel Beam Joints with Bolted End-plate

Finite Element Simulations of Unequal-Depth Panel Zones in Steel Beam-to-tubular Column Joints

Study Of Mechanical Performance Of Concrete-Filled Steel Tubular Joints

Experimental Study of Confined Hot-Rolled H-shape Steel Columns under Cyclic Loading

Performance of Concrete-Encased CFST Column-to-beam 3-D Joints under Seismic Loading: Analysis

Behaviour of concrete-encased concrete-filled steel tubular column to steel beam joints under cyclic loading

Finite element analysis on static and dynamic performance of composite beam-to-column joint

Cyclic behaviour of prefabricated connections for steel beam to concrete filled steel tube column

EXPERIMENTAL RESEARCH AND NONLINEAR FINITE ELEMENT ANALYSIS ON NEW TYPE JOINT BETWEEN COLUMN AND STEEL BEAM OF CONCRETE-FILLED RECTANGULAR STEEL TUBULAR

EXPERIMENTAL INVESTIGATION ON CYCLIC PERFORMANCE OF CFST COLUMN-RC BEAM JOINTS ENCLOSED BY REBARS

BEHAVIOR OF CFST-COLUMN TO STEEL-BEAM JOINTS IN THE SCENARIO OF COLUMN LOSS

Experimental investigation on joints between steel-reinforced concrete T-shaped column and reinforced concrete beam under bidirectional low-cyclic reversed loading

Cyclic testing on prefabricated joints for steel beam to concrete-filled steel tubular column

Behaviour of Composite Joints with Concrete Encased Cfst Columns under Cyclic Loading: Experiments

Seismic Behaviour of Steel Beam to Concrete-filled Steel Tubular Column Joints

Behaviour Of Reinforced Joints Between Steel Beam And L-Shaped Wide Limb Composite Column

Experimental and numerical investigation of the hysteretic behavior of reinforced concrete column-steel beam interior joints under low seismic intensity levels

Seismic behaviour of steel beam to circular CFST column assemblies with external diaphragms