Abstract:Hydropower has been the leading renewable source and cheapest ways to generate electrical energy in the world. In recent years, there has been a major upsurge in the hydropower development because of the use of pump as turbine (PAT). However, the operational reliability of a PAT is greatly affected by the unsteady flow fields; therefore, it is important to examine the unsteady flow behavior which can be used as a reference to reduce the noise, vibration, and cavitation performance for centrifugal pumps working as turbines. Thus, the objective of this study was to evaluate the unsteady flow fields by analyzing the distribution of the pressure pulsations using both numerical and experimental measurements in a PAT operating in pump mode. Firstly, the three‐dimensional (3D) unsteady flow equations were solved using SST <i>k‐</i>ω turbulence model during the numerical calculations. Secondly, the numerical results of the hydraulic pump performance were validated by the experimental measurements for numerical accuracy. Lastly, pressure transducers are positioned at certain monitoring points to measure the pressure in the PAT investigated. The numerical and experimental results show that the main frequency of the pressure pulsation is equal to the blade frequency, and as it deviates from the design operating condition, the magnitude of pressure pulsation intensifies. Furthermore, the impeller eye marked the lowest pressure coefficients especially at the design condition and makes it highly susceptible to cavitation. High pressure coefficients were obviously seen at the pressure side on the blade surface closer to the trailing edge at all studied operating conditions. Meanwhile, the rotor‐stator interaction generated the highest pressure pulsation distribution at the volute tongue. Thus, modification of the volute tongue is an optimal approach of reducing the pressure pulsation intensity in the volute and pump as a whole.

Hydraulic piston pump in civil aircraft: Current status, future directions and critical technologies

Research Status of the High Speed Aircraft Piston Pump

Experimental and numerical investigations on pressure pulsation in a pump mode operation of a pump as turbine

Design and control of the hydraulic reciprocating pump

An Investigation into the Swash Plate Vibration and Pressure Pulsation of Piston Pumps Based on Full Fluid-Structure Interactions

Development of an Intelligent Electric Motor-Driven Pump with High Energy Efficiency

A review of high-speed electro-hydrostatic actuator pumps in aerospace applications: Challenges and solutions

A Novel Pulsation Attenuator for Aircraft Piston Pump

Two-dimensional Piston Pump: Principle, Design, and Testing for Aviation Fuel Pumps

Effect of Structural Parameters on Output Characteristics of a Novel Self-Supplied Aviation Intelligent Pump

Investigation into the Effects of the Variable Displacement Mechanism on Swash Plate Oscillation in High-Speed Piston Pumps

Hydraulic Power Systems for Trunk Line Aircrafts

Design Method of Water Jet Pump Towards High Cavitation Performances

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

The Hydraulic System Design of High Pressure Servo-control Pulse Test Bed

Research on the Operating Characteristics of Hydraulic Free-Piston Engines: A Systematic Review and Meta-Analysis

Analysis of Cavitation Characteristics of High Temperature Fuel Piston Pump in the Process of Suction and Discharge

Effect of Piston-Slipper Assembly Mass Difference on the Cylinder Block Tilt in a High-Speed Electro-Hydrostatic Actuator Pump of Aircraft

Research Status, Critical Technologies, and Development Trends of Hydraulic Pressure Pulsation Attenuator

A Brushless DC motor design for an aircraft electro-hydraulic actuation system

CONCEPT OF POWER TRANSFER UNITS DEVELOPMENT IN CIVIL AIRCRAFT HYDRAULIC SYSTEM