Abstract:This study presents a novel roller piston pump,in which a cam guide-roller type rolling support is adopted to replace the sliding pair support of the swash plate-slipper pair to achieve the oil suction and discharge of the piston cavity.In addition,the shaft distribution is used to replace the original valve plate distribution and the driving shaft is used as the distribution shaft to remove the valve plate structure,which greatly simplifies the design of the axial piston pump.Such a configuration largely reduces the number of sliding friction pairs of the pump,and avoids the influence of the sliding friction pair on it under high-speed and variable-speed conditions.Firstly,mathematical models of the mechanical and volumetric efficiencies of the roller pump are deduced respectively through force analysis and the compressibility equation.Based on the numerical simulation of MATLAB and AMESim,the effects of load pressure and rotational speed on mechanical and volumetric efficiencies are studied respectively,and it is verified that the roller pump has no structural flow pulsation.The prototype pump is then designed and built,along with a special test rig.The outlet pressure,outlet flow,and torque of the pump under different load pressures and rotational speeds are measured,and the mechanical and volumetric efficiencies of the prototype pump under various load pressures and rotational speeds are obtained.The experimental results are in good agreement with the simulated analysis.When the load pressure is 8 MPa and the speed is 5000 r/min,the mechanical and the volumetric efficiencies are 85.5%and 96.8%,respectively.When the speed is increased to 10000 r/min,the mechanical and the volumetric efficiencies are 66.7%and 95.6%,respectively.The experimental results show that the proposed roller piston pump has excellent efficiency under wide-speed and high-speed conditions and can be a potential solution as a fuel pump in aerospace fuel systems.

Two-dimensional Piston Pump: Principle, Design, and Testing for Aviation Fuel Pumps

Design strategy and performance evaluation of novel miniature two-dimensional (2D) piston pump with a dual stacking mechanism

Flow characteristics simulation and low-noise design of fuel piston pump

Theoretical and Experimental Investigation on the Efficiency of a Novel Roller Piston Pump

New Distributing Mechanism for High Speed Single-Piston Axial Piston Pump

58812 ANALYSIS OF THE PISTON/CYLINDER PAIR OF AXIAL PISTON PUMP BASED ON VIRTUAL PROTOTYPE(Fluid-Structure Interaction in MBS)

Finite Element Analysis on Piston of Axial Piston Pump Based on Virtual Prototype

Research on the Volumetric Efficiency of a Novel Stacked Roller 2D Piston Pump

A Novel Pulsation Attenuator for Aircraft Piston Pump

Development of an Intelligent Electric Motor-Driven Pump with High Energy Efficiency

Modeling and Simulation on Axial Piston Pump Based on Virtual Prototype Technology

Research on the Performance of a Centrifugal Aviation Fuel Pump Based on Response Surface Methodology

Optimization of the Outlet Unloading Structure to Prevent Gaseous Cavitation in a High-Pressure Axial Piston Pump

Study on the efficiency characteristics of a stacked cone two-dimensional piston pump

Research on Pressure Pulsation Characteristics of Axial Piston Pump Based on Virtual Prototype

Raising the Speed Limit of Axial Piston Pumps by Optimizing the Suction Duct

Outlet Pressure and Flow Characteristics of a New Two-Dimensional Piston Pump with an Overlapped Distributor

Valve Plate Structural Optimal Design and Flow Field Analysis for the Aviation Bidirectional Three-Port Piston Pump

Research Status of the High Speed Aircraft Piston Pump

Design of Contra-Rotating Waterjet Pump Based on High Cavitation Performances

Investigation on the Radial Micro-Motion about Piston of Axial Piston Pump