Abstract:Semitransparent organic solar cells (ST-OSCs) are an important branch of organic solar cells, which have considerable application prospects in building photovoltaic, smart greenhouses, and clean energy vehicle sky-lights. However, a compromise between the power conversion efficiency (PCE) and the average visible transmittance (AVT) has been the obstacle in the field of ST-OSCs. Therefore, comprehensive consideration of PCE, AVT and the resulting light utilization efficiency (LUE), is very necessary to objectively evaluate the performance of a ST-OSC device. Herein, we report a facile strategy by combination of the advantages of the highly photo-voltaic materials with highly transparent materials to construct high performance ternary active layer for ST-OSCs. Two ternary systems PM6:PCE10-2F:Y6 and PCE10-2F:PM6:Y6 are developed according to their host bi-nary blends PM6:Y6 (w:w = 1:1.2) and PCE10-2F:Y6 (w:w = 1:2.5) respectively. The PCEs of the opaque and transparent devices are observed to be both improved in the ternary systems relative to their corresponding host systems, due to the complementary absorption, optimized morphology and charge dynamics. More importantly, combination of highly photovoltaic materials with highly transparent materials enables a well-balanced PCE and AVT, leading to significantly enhanced LUE. For PM6:PCE10-2F:Y6 devices, simultaneously improved PCE and AVT are obtained. Intriguingly, ST-OSC based on PCE10-2F:PM6:Y6 achieves an impressive PCE of 12.25 % and a high AVT of 36.57 %, which is the highest efficiency for the AVT over 30 %. A maximum LUE of 4.48 % is also a breakthrough of the ST-OSCs without complex photo-coupling layers. These findings demonstrate that combination of the high PCE system with high AVT system is a promising strategy for developing high performance ST-OSCs.

Semi-transparent photovoltaics using ultra-thin Cu(In,Ga)Se2 absorber layers prepared by single-stage co-evaporation

Semitransparent and Bifacial Ultrathin Cu(In,Ga)Se2 Solar Cells Via a Single-Stage Process and Light-Management Strategy

Bifacial Photovoltaic Performance of Semitransparent Ultrathin Cu(In,Ga)Se2 Solar Cells with Front and Rear Transparent Conducting Oxide Contacts

Optoelectronic Effects of Copper–Indium–Gallium–Sulfur (CIGS2)-Solar Cells Prepared by Three-Stage Co-Evaporation Process Technology

Effect of Se Flux on CuGaSe 2 Absorbers Deposited on ITO-coated SLG Substrates by Using a Three-Stage Co-Evaporation Process

Bifacial semi-transparent ultra-thin Cu(In,Ga)Se2 solar cells on ITO substrate: How ITO thickness and Na doping influence the performance

10.3%-Efficient Submicron-Thick Cu(In,Ga)Se2 Solar Cells with Absorber Fabricated by Sputtering In2Se3, CuGaSe2 and Cu2Se Targets

Semitransparent Perovskite Solar Cells with an Evaporated Ultra‐Thin Perovskite Absorber

Combination of Highly Photovoltaic and Highly Transparent Materials Enables Record Performance Semitransparent Organic Solar Cells

A simple and robust route toward flexible CIGS photovoltaic devices on polymer substrates: Atomic level microstructural analysis and local opto-electronic investigation

Semitransparent perovskite solar cells with an evaporated ultra-thin perovskite absorber

Numerical Simulation of Copper Indium Gallium Diselenide Solar Cell with Ultra-Thin BaSi2 Back Surface Field Layer Using the Non-Toxic In2Se3 Buffer Layer

Preparation of Cu(In,Ga)Se2 Thin Film by Sputtering from Cu(In,Ga)Se2 Quaternary Target

Semitransparent perovskite solar cells with ultrathin silver electrodes for tandem solar cells

Carrier transport and performance limit of semi-transparent photovoltaics: CuIn$_{1-x}$Ga$_x$Se$_2$ as a case study

Characterization of Cu(In,Ga)Se2 Films Deposited by Single-Step Electron Beam Evaporation for Solar Cell Applications

Study on the Thickness Effect of Wide-Bandgap CuGaSe2 Thin Films for Applications with Tandem Solar Cells

Semitransparent Single-Junction and Tandem Solar Cells Using Microcrystalline Silicon for Energy-Harvesting Photovoltaic Windows

Application of Bifacial Semitransparent CuInSe2 Absorber to the Bottom Cell in Bifacial Semitransparent Perovskite/CuInSe2 Tandem Solar Cell for Albedo Environment (Small 9/2024)

Investigation on the Performance of CIGS/TiO2 Heterojunction Using SCAPS Software for Highly Efficient Solar Cells

Design of suppressing optical and recombination losses in ultrathin CuInGaSe2 solar cells by Voronoi nanocavity arrays