Reduced graphene oxide-induced crystallization of CuPc interfacial layer for high performance of perovskite photodetectors

Zou Taoyu,Zhang Jianqi,Huang Shuyi,Liu Chenning,Qiu Renzheng,Wang Xiaozhi,Wu Wei,Wang Hai,Wei Zhixiang,Dai Qing,Liu Chuan,Zhang Shengdong,Zhou Hang
DOI: https://doi.org/10.1039/c8ra08864k
IF: 4.036
2019-01-01
RSC Advances
Abstract:Perovskite-based photodetectors have great potential in light-signal conversion; the suppression of the dark current is regarded as one of the main concerns within the academic research communities to achieve a high-performance photodetector. Interfacial engineering in the transport layer is considered as one of the most essential methods for enhancement of perovskite photodetectors. Here, a nanocomposite thin film of tetra-sulfonated copper phthalocyanines and reduced graphene oxide (TS-CuPc/rGO) was investigated as the interfacial layer in perovskite-based photodetectors. Photodetectors with the TS-CuPc/rGO thin film as the interfacial layer exhibited a low dark current density of 2.2 x 10(-8) A cm(-2) at bias of -0.1 V as well as high responsivity and detectivity of similar to 357 mA W-1 and similar to 4.2 x 10(12) jones, respectively; moreover, we observed an ON/OFF ratio of 7.33 x 10(3) to 520 nm light with an intensity of similar to 0.077 mW cm(-2). Our study revealed that with rGO additives, TS-CuPc molecules were favorable for the formation of an edge-on stacking film with high crystallinity. The rGO-induced crystalline TS-CuPc thin film with lower crystallographic defects effectively reduced the carrier recombination rate at the interfaces, leading to a suppressed dark current and enhanced photocurrent in the photodetector device, when compared to the less crystalline TS-CuPc layer.
What problem does this paper attempt to address?