Abstract:Visible light communications (VLC) utilizing LEDs for transmissions have been widely considered a revolutionary solution for next-generation networks such as 6G. Frequency response (FR) is of great importance for LEDs, but the inherent internal quantum efficiency (IQE) of LEDs is often disregarded, resulting in imprecise FR models. Although it is widely known that IQE varies with the injected direct current (DC), the impact of IQE on the frequency response has not been thoroughly analyzed. To address this issue, we have developed a precise electro-optical (E-O) FR model by incorporating the ABC model of IQE, named IQE-FR. To validate the accuracy of IQE-FR, we conducted the experiments using commercial off-the-shelf (COTS) LEDs including a tri-color LED and three monochromatic LEDs. The IQE-FR model aligns well with the experimental findings in terms of the maximum FR value, while state-of-the-art FR models that ignore the IQE effects do not yield consistent results. Specifically, we discovered that the red LEDs exhibit a stable DC gain when the biasing current rises to 300 mA, but the highest DC gain for green and blue LEDs can only be achieved under 100 mA. For green and blue LEDs, the biasing currents are much lower than their typical working currents (350 mA and 500 mA). To address the trade-off between luminance and DC gain, we propose cascading multiple LEDs operating at a low current corresponding to the maximum response. Experimental results demonstrate that four cascaded monochromatic LEDs exhibit similar bandwidth and response gain larger than 11 dB compared to a single LED at the same biasing current while delivering four times the emission power, which is very close to the theoretical value of 12 dB. Furthermore, we find that the DC gain improvement by cascading multiple LEDs is nonlinear and bounded by an upper limit as the number of LEDs increases, and as a cost-effective solution, a few tens of LEDs is recommended. To the best of our knowledge, this is the first attempt to apply the IQE model to study the LEDs’ precise FR performances for VLC. We believe that the precise IQE-FR model opens new avenues for optimizing VLC system performance by considering the effects of IQE.

Estimating Internal Quantum Efficiency of Light-Emitting Diodes from Current–voltage Curves

Accurate Optical Optimization of Light-Emitting Diodes with Consideration of Coupling Between Purcell Factor and Transmittance Coefficient

Evaluation of Internal Quantum Efficiency of Blue Light Emitting-Diodes

Study on Optical Properties and Internal Quantum Efficiency Measurement of GaN-based Green LEDs

Exploring an InGaN Micro-LED structure for optimum IQE operating on low current condition through simulation study

Optimizing InGaN Micro-LED Efficiency: Investigating the Internal Quantum Efficiency and Ideality Factor Connection

Internal quantum efficiency improvement of InGaN/GaN multiple quantum well green light-emitting diodes

Prediction of Photoelectric Properties, Especially Power Conversion Efficiency of Cells, of IQ1 and Derivative Dyes in High-Efficiency Dye-Sensitized Solar Cells

Iodide capped PbS/CdS core-shell quantum dots for efficient long-wavelength near-infrared light-emitting diodes

Joint Evaluation of Internal Quantum Efficiency and Light Extraction Efficiency for AlGaN-based Deep Ultraviolet LEDs Considering Optical Polarization Properties

Modelling Charge Transport and Electro-Optical Characteristics of Quantum Dot Light-Emitting Diodes

Quantitative Evaluation of Carrier Dynamics in Blue Micro-LEDs: the Impact of Size and Current Density on Recombination and Injection Efficiency

A Simulation Study on the Enhancement of the Efficiency of GaN-based Blue Light-Emitting Diodes at Low Current Density for Micro-Led Applications

Precise Frequency Response of COTS LED for VLC Using Internal Quantum Efficiency Metric

The Quantum Efficiency Of Green Gainn/Gan Light Emitting Diodes

Boosting the efficiency of inverted quantum dot light-emitting diodes by balancing charge densities and suppressing exciton quenching through band alignment

Improving Peak-Wavelength Method to Measure Junction Temperature by Dual-Wavelength Leds

Efficient Green InP-based QD-LED by Controlling Electron Injection and Leakage

Analysis of the Quantum Efficiency of Gainn/Gan Light Emitting Diodes in the Range of 390-580 Nm

Quantum Mechanical Modeling of Nanoscale Light Emitting Diodes

Highly Efficient Top‐Emitting Quantum‐Dot Light‐Emitting Diodes with Record‐Breaking External Quantum Efficiency of over 44.5%