Abstract:Interleaved power factor correction (PFC) is widely used circuit topology due to good efficiency and power density for single-switch boost PFC. As the differential mode (DM) electromagnetic interference (EMI) noise magnitude depends upon the input current ripple, this research details a comprehensive study of DM EMI filter design for interleaved boost PFC with the aim of minimizing the component size. It is also demonstrated that the different numbers of interleaved stages and switching frequency influence the filter attenuation requirement and, thus, the EMI filter size. First, an analytical model is derived on the basis of the Norton equivalent circuit model for the differential mode noises of interleaved boost PFC within the frequency range of 9–500 kHz. The derived model can help identify the proper phase shifting among the interleaved boost converters in order to minimize the considered differential mode noises at the filter design frequency. So, a novel phase-shift method is developed to get a minimized attenuation required by a filter in Band B. Further, a volume optimization of the required DM filter was introduced based on the calculated filter attenuation and volumetric component parameters. Based on the obtained results, unconventional and conventional phase shifts have demonstrated a good performance in decreasing the EMI filter volume in Band B and Band A, respectively. A 2-kW interleaved PFC case study is presented to verify the theoretical analyses and the impact of phase-shifting on EMI filter size.

Analysis and Suppression of Common-mode EMI in Three-phase Vienna PFC Circuit

A Systematic Design and Optimization Technique for the Suppression of EMI Common Mode (CM) Noise

A New Common-mode EMI Reduction Method for PFC-LLC Power Module

Analysis and Suppression of Common Mode Interference in Three-Phase Power Rectifier Unit Based on Common Mode Transformer

EMI Filter Design Based on High-Frequency Modeling of Common-mode Chokes

A Novel Common-Mode Conducted EMI Filter for Boost PFC Converter

Mirror-Bridge Phase-Shift Modulation With Low Common-Mode Noise for Single-Phase CHB PFC

ANALYSIS ON THE EMI EFFECT OF STRAY MAGNETIC FIELD FROM MAIN CIRCUIT OF A PFC SWITCHED MODE POWER SUPPLY

PFC converter with novel integration of both EMI filter and Boost inductors

EMI Modeling Method and Active Suppression Technology of Common-Mode Electromagnetic Interference in Three-Phase Two-Level Inverter Based on Four-Bridge Topology

Near Field Effect Analysis and Common Mode Conducted EMI Model of a Switched Mode Power Supply

Design of Active EMI Filters with the Integrated Passive Component

Analysis and Suppression of Inductive Interference in Active Integrated Power Electronics Module

Identification and Model of Near Field Magnetic Coupling in A Pfc Converter

Design and Experiment Research of Integrated EMI Filter Based on Flexible Multi-Layer Foils

Measurement and Suppression of Common-mode and Differential-mode EMI in PWM Converter System

Analysis and Suppression of Conductive EMI Originated by an Active Power Filter

Conducted EMI Noise Analysis Model for PFC Converters Based on Modeling of EMI Receiver

Common-Mode EMI Modeling and Analysis for GaN-Based Full-Bridge CRM PFC under Unipolar PWM Scheme

Differential Mode Noise Estimation and Filter Design for Interleaved Boost Power Factor Correction Converters

High Frequency Common Mode EMI Noise Suppression for Switching Converters by Impedance Control