Abstract:A feasibility study on the compensation of 3D mispositioning errors of the probe occurring in the characterization of a long antenna, via a non-redundant (NR) near to far-field (NTFF) transformation with helicoidal scan, is conducted in this article. Such types of errors can result from imperfections in the rail driving the linear motion of the probe and from an imprecise synchronization of the linear and rotational movements of the probe and the antenna when drawing the scan helix. To correct them, an approach, which proceeds through two steps, is proposed. The former step uses a technique called cylindo rical wave (CW) correction for compensating the phase of the near-field (NF) samples, which, owing to the rail imperfections, result in not being acquired over the measurement cylinder surface. The latter exploits an iterative scheme to restore the samples at the sampling points required by the adopted NR representation along the scan helix from those obtained by applying the CW correction technique and impaired by 2D mispositioning errors. The so compensated NF samples are then effectively recovered via a 2D optimal sampling interpolation (OSI) scheme to accurately obtain the input data required to carry out the standard cylindrical NTFF transformation. The OSI representation is determined here by assuming a long antenna under test as enclosed in a prolate ellipsoid or cylinder ending into two hemispheres (cigar) in order to make, depending on the particular geometry of the considered antenna, the representation effectively non-redundant. The reported numerical simulation results show the capability of the proposed approach to compensate even severe 3D mispositioning errors, thus enabling its usage in a real measurement scenario.

Analysis and Correction of Probe Location Errors in Spherical Near-Field Antenna Measurement

Analytical Calculation of the Measuring Error of an Electromagnetic Velocity Probe Caused by a Side Channel Wall

Divisionally Analytical Reconstruction of the Magnetic Field Around an Electromagnetic Velocity Probe

Phaseless Probe-Corrected Spherical Near-Field Antenna Measurements Using Two Scan Spheres

Error Analysis Of Spherical Ultra-Precision Measurement

An Efficient Probe Calibration Based Near-Field to Near-Field Transformation for EMI Diagnosis

Patch Antenna Radiation Pattern Evaluation Based on Phaseless and Single-Plane Near-Field Scanning

A Novel Near-field Calibration Method for Linear Array Based on Plane Wave Expansion

A study on calibration compensation and perturbation of electromagnetic probes

Probe Design and Source Reconstruction for Near-Field Scanning and Modeling

Study of Planar Near-Field Measurements Methods for Determining the Gain of the Antenna

An Efficient Procedure to Compensate for the Errors Due to the Probe Mispositioning in a Cylindrical Near-Field Facility

An Efficient Antenna Measurements Method in Spherical Near Field Based on Sparse Sampling

Three-Dimensional Probe Mispositioning Errors Compensation: A Feasibility Study in the Non-Redundant Helicoidal Near to Far-Field Transformation Case

Combined Application of Partition Clustering Classification and Gerchberg-Papoulis Optimization Algorithm for Spherical Near Field Antenna Measurements

The Position Sampling Affect on Error in Planar Near-Field Radiation Measurement

An Effective Antenna Pattern Reconstruction Method for Planar Near-Field Measurement System

Far-field pattern accuracy improvement in planar near-field measurement using infinitesimal dipole modeling

Near-Field Measurement for Antenna Polarization

A Miniature Multi-Component Probe for Near-Field Scanning

Analysis and Simulation of System Phase Errors in Planar Near-Field Measurements on Ultra-Low Sidelobe Antennas