Abstract:The mechanism of stabilizing a turbulent premixed methane-air flame using warm filamentary plasma is investigated by using laser diagnostics. First, stabilization of a turbulent jet flame is demonstrated in a setup using a pin-to-pin plasma discharge. The coupled plasma-flame structures were visualized utilizing planar laser-induced fluorescence (PLIF) of formaldehyde (CH2O) and methylidyne radicals (CH), as well as laser Rayleigh scattering thermometry imaging. The results show that the plasma channel and the flame front are spatially separated by a layer of hot burning products attributed to the flame propagation from the plasma core. Because of this spatial separation, the impacts of plasma on combustion are primarily thermal since the energetic radical species (such as O, H), produced by the discharge, have short equilibration time and cannot spread far away from the discharge channel before reaching the equilibrium state. From this point of view, turbulence would be beneficial for promoting the transport of plasma-produced radicals and thus bridge the gap between the plasma and the flame front. The plasma is still able to stabilize the flame. Based upon the experimental results, a frequent ignition-flame propagation (FIFP) model is proposed to explain the flame stabilization process. For the contracted plasma filament, the local power density is high enough to initialize the flame kernel that propagates away from the plasma channel until extinction. The propagation process is, however, strongly affected by turbulence. Local extinction is highly probable and thus the flame front has to be close to the ignition source at strong turbulence. At such conditions, the stabilized flame can be regarded as a large number of flame pockets, repeating the three phases of ignition, propagation and extinction, which can be summarized as the FIFP model. It infers that the flame propagation phase is important for sustaining the flame to complete combustion. Hence, this phase should be extended, which is more probable to achieve if the plasma ignition pilot is located in a section of limited turbulence.

Stabilization of Premixed Swirl Flames Under Flow Pulsations Using Microsecond Pulsed Plasmas

Spray Swirling Flame Dynamic under Combined Modulation of Air and Fuel

Blowout Dynamics and Plasma-Assisted Stabilization of Premixed Swirl Flames under Fuel Pulsations

Inlet Pulsation-Induced Extinction and Plasma-Assisted Stabilization of Premixed Swirl Flames

Plasma-assisted Stabilization of Premixed Swirl Flames by Gliding Arc Discharges

Stabilization of a Turbulent Premixed Flame by a Plasma Filament

Extension Of Flammability And Stability Limits Of Swirling Premixed Flames By Ac Powered Gliding Arc Discharges

Effect of Rotating Gliding Arc Plasma on Lean Blow-Off Limit and Flame Structure of Bluff Body and Swirl-Stabilized Premixed Flames

Flame Interaction and Stabilization Mechanisms in a Dual Premix Swirl Combustor with a Pilot Bluff Body

Laser Ablation Plasma-Assisted Stabilization of Premixed Methane/air Flame

Effects of flow-flame interactions on the stabilization of ultra-lean swirling CH<sub>4</sub>/H<sub>2</sub>/air flames

Effect of confinement ratio on flame structure and blow-off characteristics of swirl flames

Stabilization of Premixed High Flow Speed Methane/Air Flames Using A Nanosecond Laser Induced Plasma

Stabilization of a Premixed Methane-Air Flame with a High Repetition Nanosecond Laser-Induced Plasma

Experimental Study on Flame/flow Dynamics in a Multi-Nozzle Gas Turbine Model Combustor under Thermo-Acoustically Unstable Condition with Different Swirler Configurations

Stabilization of a Premixed CH4/O2/N2 Flame Using Femtosecond Laser-Induced Plasma.

Flame Stability Analysis Of Premixed Hydrogen/Air Mixtures In A Swirl Micro-Combustor

Non-premixed Flame Dynamics Excited by Flow Fluctuations Generated from Dielectric-Barrier-Discharge Plasma

Ignition and Stabilization of a Premixed Methane/air Flame with Repetitive Laser-Induced Plasmas

Pulsating Instability of Externally Forced Premixed Counterflow Flame

Flow, Mixing, and Flame Stabilization in Bluff-Body Burner with Decreased Central Jet Velocity