Abstract:Partial discharge measurement plays an important role in the assessment of insulation status and fault diagnosis of power equipment. Presently, the most commonly used industrial applications of PD detections are based on the broadband measurement systems that count amplified PD pulses. The limitations of these traditional measurements are that the system requires a relatively high sampling rate and calculation capability, and is very sensitive to the ambient noise. To eliminate noise interference and save the cost of PD detection system, a technique measurement of excess currents, which measures the dielectric response currents through test object before and after PD activities to capture the activities of PD, has been reported in some recent studies. This work aims to explore the parameters that characterize the PD activities via excess current technology and to seek new ideas for PD detection. In this work, a measurement setup for measurement of PD excess currents averaged from 300 periods is applied and three typical insulation defect models were tested under 50Hz voltages. Excess currents for each case are measured. Then the corresponding dielectric loss factors and circuit impedances are obtained by comparing them to the synchronous voltages. The results show that the loss factors increase after PD while the circuit impedances decrease. Meanwhile, the loss factors continue to increase and the circuit impedances continue to decrease as the voltages turn up where the rate of the change shows more rapid in the needle-plate model. Moreover, the loss factors and circuit impedances in the dielectric barrier model and air void model are respectively higher and lower than the values before PD when the voltages drop below the PD extinction voltages, which does not appear in the needle-plate model. These characteristics provide a new idea for PD detection by monitoring the loss factors or circuit impedances via excess current detection.

High Accuracy Insulation Fault Diagnosis Method of Power Equipment Based on Power Maximum Likelihood Estimation

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

A Research on Regional Detection and Precise Location of Partial Discharge in Substations

A Novel Partial Discharge Localization Method in Substation Based on a Wireless UHF Sensor Array

Research on a General Fast Analysis Algorithm Model for PD Acoustic Detection System: Pattern Identification with Phase Compensation

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

On Site Detection and Localization of Partial Discharge in Hydropower Plant GIL/GIS Based on Ultra-high Frequency Technique

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Separating Multi-Source Partial Discharge Signals Using Linear Prediction Analysis and Isolation Forest Algorithm

Implementation of A Novel Double-Side Technique for Partial Discharge Detection and Location in Covered Conductor Overhead Distribution Networks

Partial Discharge Monitoring and Locating in Substation <br/>Using Multiple Sensors in Parallel

The Application of Partial Discharge Detection for the Condition Assessment of Xlpe Power Cables

Detection and Identification Technologies of Wide Band Partial Discharge

On-Line Partial Discharge Localization of 10-Kv Covered Conductor Lines

Application to Real Power Networks of a Method to Locate Partial Discharges Based on Electromagnetic Time Reversal

A Technique to Identify the Types of Partial Discharges

Noise Reduction of Partial Discharge in Power Cable Insulation Based on Deep Learning

Research on Partial Discharge Signal Detection Based on UHF Sensor Array and Eigenvalue Behavior Analysis

Partial discharge detection on power equipment using a magneto-resistive sensor

Research on Detection Method of PD Detection with Special-shaped Wave

Application of Ultra-high-frequency Partial Discharge Detection in Power Transformers