Abstract:In view of the fact that the partial discharge (PD) signal energy is mainly concentrated below hundreds of megahertz, the ultra-high frequency part of the energy is weak, and the interior space of the switchgear is narrow, this paper proposes a new method for PD detection of the switchgear based on near-field detection. Firstly, based on the principle of PD, the field characteristics of the signal in the switchgear are analyzed. After that, the probe is designed with an electric small loop structure. Based on its equivalent circuit, its measurement principle and amplitude frequency characteristics are analyzed. The influence of probe size and material on amplitude frequency characteristics is obtained by using simulation software High Frequency Structure Simulator (HFSS), and the probe parameters suitable for PD detection in the switchgear are determined. Finally, the performance of the probe is measured by network analyzer, and the PD signal is tested on the simulated PD test platform. The results show that the probe works in the frequency band of 10–200 MHz and can receive PD signals containing more energy information. In the operating frequency band, the reflection coefficient of the probe port is very large, and its interference to the signal near field is particularly small. The probe also has good frequency response characteristics, and the fluctuation in the frequency band is less than 5 dB, which can obtain more accurate PD signal characteristics in subsequent processing. In addition, the probe is passive, with dimensions of 166 mm in length, 104 mm in width, and 2 mm in thickness, which is suitable for placing in the switchgear with small internal space. The results of PD receiving test show that the probe can reflect the occurrence of PD remarkably and accurately.

Research on Detection Method of PD Detection with Special-shaped Wave

Detection and Identification Technologies of Wide Band Partial Discharge

Research on Characteristics of Acoustic Signal of Typical Partial Discharge Models

Research on a General Fast Analysis Algorithm Model for PD Acoustic Detection System: Pattern Identification with Phase Compensation

Partial discharge detection for GIS using narrow band ultra-high-frequency (UHF) method

Use of UHF Method to Extract Partial Discharge Signal under Square-wave Pulse

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

Time–frequency characteristics of abnormal waveshapes in PD pulse sequence using ultra-wideband detection

Design of Test and Detection System for Partial Discharge under DC Voltage

High Accuracy Insulation Fault Diagnosis Method of Power Equipment Based on Power Maximum Likelihood Estimation

Investigation of PD electromagnetic wave characteristics in GIS

An Advanced Method for Detection of Partial Discharge in Oil-Paper Insulated Transformer Bushings and Current Transformers

Application of Ultra-high-frequency Partial Discharge Detection in Power Transformers

Implementation of A Novel Double-Side Technique for Partial Discharge Detection and Location in Covered Conductor Overhead Distribution Networks

Comparison of Pd Detection Methods for Power Transformers - Their Sensitivity and Characteristics in Time and Frequency Domain

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Partial Discharge Detection in Gas-Insulated Switchgears Using Sensors Integrated with UHF and Optical Sensing Methods

Research on a New PD Detection Sensor in Transformer Oil Tank Seam

Current Situation and Development of Optical Detection for Partial Discharge

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Study on pulse current of typical PD models in power transformer