Abstract:The off-design characteristics of an improved recompression supercritical carbon dioxide cycle integrated with a two-stage intercooled main compressor are investigated with a focus on the concentrated solar power application. An off-design model is established for each crucial component of the cycle system of 100-megawatt scale. Four cycle control schemes with different main compressor configurations or/and cycle maximum pressure modes are evaluated and compared. A sensitivity analysis is performed on the parameters related to the cycle thermal input and ambient condition to predict the off-design characteristics due to the plant dispatch and ambient condition change in a solar power plant. The off-design results regarding the cycle thermodynamic performance and operational issue prevention are presented. The effect of the design-point value of the main compressor inlet temperature on the off-design characteristics is evaluated with the comparison among the results at three design points. The results reveal that the compressor surge may occur to the main compressor with basic configuration as the main compressor inlet temperature decreases to a certain value beneath the corresponding design point. By contrast, the surge risk can be prevented with the modified main compressor configuration by activating the recirculation system and the cycle can thus operate normally in the entire off-design range of main compressor inlet temperature. The off-design change in thermal input has overall limited effects on the cycle system control. No operational compressor issues occur for the main compressor with either basic or modified configuration as the thermal input deviates from the design points and varies in the studied ranges. The cycle maximum pressure mode has slight effects on the cycle thermodynamic performance as the thermal input deviates from the design point. The flexible cycle maximum pressure mode has slightly lower sensitivity to the thermal input variation in net output power due to the counteraction of mass flowrate variation. The selection of the design-point value of the main compressor inlet temperature has significant effects on the off-design characteristics of the cycle. A low design-point value of the main compressor inlet temperature leads to less demanding control action for operational issue prevention whereas a high design-point main compressor inlet temperature results in overall more stable thermodynamic performance under off-design conditions. Among other schemes, the fixed maximum pressure mode with the modified main compressor configuration is found to be the most satisfactory one due to the consequent superior efficiency, steady net output power, and free of hazardous operating issues despite the relatively demanding task of compressor surge prevention. The developed control scheme can be further improved by implementing parametric optimization during the off-design operation.

Investigation into Off-Design Performance of a S-CO2 Turbine Based on Concentrated Solar Power

Efficient turbomachinery layout design and performance comparison of supercritical CO2 cycles for high-temperature concentrated solar power plants under peak-shaving scenarios

Design and Performance Analysis of a Supercritical CO2 Radial Inflow Turbine

Aerodynamic Design and Off-design Performance Analysis of a Multi-Stage S-CO2 Axial Turbine Based on Solar Power Generation System

An Experimental Study of Turbine Vane Film Cooling Using Endoscope-Based PSP Technique in a Single-Passage Wind Tunnel

Aerothermodynamic Design and Numerical Investigation of Supercritical Carbon Dioxide Turbine

Investigation of Off‐design Characteristics of an Improved Recompression Supercritical Carbon Dioxide Cycle for Concentrated Solar Power Application

Novel Design Optimization of Concentrated Solar Power Plant with S-CO2 Brayton Cycle Based on Annual Off-Design Performance

A comprehensive preliminary design methodology and an optimization workflow for single-stage radial-outflow turbines and application for 10 MW sCO 2 turbines

Aerodynamic Design and Numerical Analysis of a Radial Inflow Turbine for the Supercritical Carbon Dioxide Brayton Cycle

Development of Operation Strategy for Recompression Supercritical CO2 Cycle with Intercooled Main Compressor under Off-Design Condition

One-Dimensional Optimization Design of Supercritical Carbon Dioxide Radial Inflow Turbine and Performance Analysis under Off-Design Conditions

Numerical Investigation of Flow Characteristics in a Supercritical Carbon Dioxide Turbine for 20 Megawatt Brayton Cycle

Investigation on Steady Aerodynamic Performance of a S-CO2 Compressor with Different Diffusers in Solar Power System

Thermal Design and CFD Analysis of the Radial Inflow Turbine for a CO 2 ‐based Mixture Transcritical Rankine Cycle

Performance and Loss Analysis of a Small-Scale Supercritical CO2 Turbine

Vortex Patterns Investigation and Enstrophy Analysis in a Small Scale S-CO2 Axial Turbine

Off-design Performance Comparative Analysis of a Transcritical CO2 Power Cycle Using a Radial Turbine by Different Operation Methods

Aerodynamic Optimization Of A Sco2 Radial-Inflow Turbine Based On An Improved Simulated Annealing Algorithm

Dynamic Characteristics and Control Strategies of the Supercritical CO2 Brayton Cycle Tailored for the New Generation Concentrating Solar Power

A Multi-Factor Comprehensive Optimization of a Supercritical Carbon Dioxide Radial Inflow Turbine with Low Specific Speed