Abstract:Methyl decanoate, methyl-5-decenoate and methyl-9-decenoate have been widely adopted as biodiesel surrogates for engine simulation. However, these surrogates have relatively short chain length and very different physical properties compared with biodiesel molecules. Additionally, it is difficult to distinguish the unsaturafion degree of different biodiesel fuels by using these surrogates. The direct use of the heavy methyl esters in real biodiesel fuels as surrogates is essential to accurately simulate biodiesel fuels. In this work, a four-part scheme to formulate skeletal mechanism for heavy saturated methyl esters has been proposed. Within the scheme, the oxidation mechanism is divided into four parts: low temperature oxidation, high temperature decomposition, ester group reactions and detailed C4-C0 chemistry. A skeletal mechanism for two of the five main methyl esters in real biodiesel fuels, i.e. saturated methyl palmitate and methyl stearate, has been constructed. The obtained skeletal mechanism contains only 6 fuel-dependent species and 13 fuel-dependent reactions for each heavy saturated methyl ester. Extensive validations were performed against shock tube experimental data for ignition delay timing under different initial pressure, temperature and equivalence ratio. The ignition delay behavior at high temperature has been well captured by the developed skeletal mechanism. As for ignition at low to medium temperature (from 650 K to 900 K), there is no experimental data due to the low vapor pressure and high melting point of heavy methyl esters. The comparison of ignition behavior at low temperature has been made between several models. Furthermore, the oxidation of n-decane/methyl palmitate and benzene/methyl stearate in a jet-stirred reactor has been utilized to validate the important species concentration. Good agreements have been observed through the validations. The results indicate that the developed skeletal mechanism is capable of predicting the combustion characteristics of methyl palmitate and methyl stearate.

Densities and Excess Molar Volumes of Methanol with Three Fatty Acid Methyl Esters from 283.15 to 318.15 K

Densities and Viscosities of Binary Mixtures of Cyclopropanecarboxylic Acid with Methanol, Ethanol, Propan-1-ol, and Butan-1-ol at Different Temperatures

Volumetric Properties of Binary Mixtures of Methanol with Ethyl Caprylate, Ethyl Caprate, and Ethyl Laurate from 283.15 to 318.15 K

Densities of FAMEs or FAEEs with Ethanol at Temperatures from 283.15 to 318.15 K

Experimental Investigations on the Thermophysical Properties of Methyl Myristate in Alcoholic Solutions

Measurement and Correlation of Viscosities and Densities of Methyl Dodecanoate and Ethyl Dodecanoate at Elevated Pressures

Densities and Viscosities of Mixtures of Methyl Dodecanoate + Ethyl Octanoate at Pressures Up to 15 MPa

General Models for Prediction Densities and Viscosities of Saturated and Unsaturated Fatty Acid Esters

Thermal Conductivity of the Binary Mixtures of N-Heptane and Fatty Acid Esters: Measurement and Correlation

Phase Equilibrium Thermodynamic Modeling For The Methanol Plus Fatty Acid Methyl Ester Systems At High Temperatures And Pressures

Experimental Investigations on the Liquid Thermal Conductivity of Five Saturated Fatty Acid Methyl Esters Components of Biodiesel

Densities, Surface Tensions, and Viscosities of Diesel−Oxygenate Mixtures at the Temperature 301.15 K

Phase Equilibrium Thermodynamic Modeling for the Methanol + Fatty Acid Methyl Ester Systems at High Temperatures and Pressures

Measurement and Correlation of the Density, Viscosity and Vapor Pressure of Fatty Acid 2-Ethyhexyl Esters

Densities and Viscosities for the Ternary Mixtures of Exo-Tetrahydrodicyclopentadiene (1) + Isopropylcyclohexane (2) + Methyl Laurate (3) and Corresponding Binaries

Measurements and Correlations of Density, Viscosity, and Vapor Pressure for Methyl Ricinoleate

Skeletal Mechanism Construction for Heavy Saturated Methyl Esters in Real Biodiesel Fuels

Isobaric Molar Heat Capacities of Dimethyl Carbonate and Alkane Binary Mixtures at High Pressures

Densities and Viscosities for the Ternary Mixture of N-Undecane (1) + Methyl Decanoate (2) + N-Butanol (3) and Corresponding Binaries from T=293.15 to 333.15 K and at Atmospheric Pressure

Measurement of sound speed in methyl caprate, methyl laurate and methyl myristate

Measurement on the Thermal Conductivity of Five Saturated Fatty Acid Ethyl Esters Components of Biodiesel